Gender
Male
About
Activity Feed
"Thanks for the suggestions, was hoping i could download software to do it but i will give dronemapper a try!"
Which software are people using to stitch geo referenced images together in order to get a scaled overall image?I have seen how to insert the geo tags into the images here >> http://code.google.com/p/ardupilot-mega/wiki/GeotaggingMicrosoft ICE and…
"No i just tried a basic triangle with 2 waypoints and it made no effort to head in the direction of the second one. There was little to no wind i could not even tell which direction it was coming from!
The Red section above is Auto and the Green is…"
The Red section above is Auto and the Green is…"
Well yesterday i maidened my Maxi Swift with my APM. It flew fine in Manual Mode and then when i went to auto it seemed to go in the direction of the first waypoint but continued on doing circles and getting further away until i could no longer see…
"Mount it components down pins left and upload the code as normal in the mission planner. No changes needed."
I am looking for a compact camera which will take shots indefinitely until the card is full. I have a pentax which will do this by holding down the trigger and it takes shots every few seconds, however i am not happy with the quality compaired to a…
Ive seen the option to enable a current sensor during setup but cant seem to find it in the wiki? Have i missed it somewhere?I have a buzzer and was wondering if it is possible to set this up to go off at a desired voltage?Cheers
"I am also experiencing the short oscillation which you have. I tried changing the D value to -0.1 and +0.1 but both were un flyable. I then lowered the P value to 0.5 and then to 0.4 and it is slightly better but still not right. I also lowered the…"
"Check the gold bullet connectors on the motors if you have them, they can fail!"
"Im getting the same mavlink bad packet error.
It works fine for updating the software but not in the sensor section??
I had it all working fine last week on a pre release version. Only got this error today when i loaded the zip'd code."
It works fine for updating the software but not in the sensor section??
I had it all working fine last week on a pre release version. Only got this error today when i loaded the zip'd code."
"Do people typically use 2mw or 50mw units? or is it just down to range you require?"
"Ok Thanks. I have soldered the board to the APM and connected it to the configurator and everything looks ok. Must just wait for my ESC's now to test everything."
"Sure, here it is. Maybe it was a board which was returned before?
[IMG]http://i41.photobucket.com/albums/e292/MB1380/IMAG0364.jpg[/IMG]
[IMG]http://i41.photobucket.com/albums/e292/MB1380/IMAG0360_1.jpg[/IMG]"
[IMG]http://i41.photobucket.com/albums/e292/MB1380/IMAG0364.jpg[/IMG]
[IMG]http://i41.photobucket.com/albums/e292/MB1380/IMAG0360_1.jpg[/IMG]"
"Yes its brand new. The sticker says " Data Flash Resistor not soldered on board" on the back and there were 4 normal (not smd) resistors enclosed in the box also...."
"Just got one of these boards and there is a sticker on it saying that the Data Flash resistor has not been soldered to the board and there are some resistors enclosed. Where does this resistor go?"
