Gender
Male
About
Location
Wakefield, RI
About Me:
DIY'er. IT/Network engineer by day, typical geek by night.
Please tell us a bit about your UAV interest
Excessive. It's all I know.
Hometown:
RI
Activity Feed
"I'm having this issue too with 3.3.3-rc2. I cannot get the internal compass to disable no matter how I adjust the settings. :("
"I have the SF10/C LiDAR and found that it only seems to work well in the 3.3.3 RC1 and now RC2."
"On my 6S build I used this: http://www.mauch-electronic.com/apps/webstore/products/show/6626809
Awesome quality. He also has a 50A and 100A."
Awesome quality. He also has a 50A and 100A."
"The newest Beta firmware seems to work perfectly. All 6 motors and LiDAR all working. I think the version I installed was 3.3.3 RC1."
"I have confirmed that the upgraded 3.3.2 I also lose channels 5 and 6."
"Great to know. My setup is a hex too but not ready for flight. I'm still finishing off the wiring after upgrading to the PixHawk."
"Sure. Let me know any progress. My copter is not complete so it's not been airborne yet but very soon it will be airborne. :-)"
"This worked. Thank you. Now is there any way to have this reading the default for altitude?"
"Oh, I'm also a ham radio operator so I felt the need to utilize the ham bands."
OK, well this is the 2nd revision of my first RC anything. The first revision was the same craft but it was using an Eagle Tree Vector controller.So far these are the parts I have:Tarot FY680 Iron ManSigma Summit Motor Mounts (~740mm now)PixHawk…
"I will try this as soon as I am home from work. Thank you. "
Hello all. I've connected a Lightware SF10/c to my pixhawk serial 4/5 port as the instructions here show:http://copter.ardupilot.com/wiki/com...re-sf10-lidar/My SonarRange is flat on 0. I can see that the unit is powered up because I can see the dot…
