Hi,
One week ago i purchased a ArduPilot from CoolComponents in the UK. Along with FTDI cable and Shield (with airspeed sensor). I am powering the AP from a Futaba R607FS 2.4Gz receiver and controlling it via a Futaba FF9 with Futaba TM-7 2.4Gz mod
in ur opinion what is popular/typical project can be done..
* camera helicopter , real time video transmitt (eye in sky)
* temp, wind , humidity , GPS sensor
* or just play with it in shining Sunday
I Just bought all the parts for Ardupilot (meaning "everything you"ll need") my plane is a 4chnl plane. If i convert to ardupilot mega, is the intallation the same as in the Manuel. Do i need fiffernt parts?
Hello,
I've been waiting a while to be completed the development of AP and its
imu Mega, I wondered that apart from the Mega AP, IMU and the GPS, which
other material is needed to run correctly on a plane the AP. Thanks
Hola, llevo un tiempo esperando a
Hi,
I finally got to try my new airframe yesterday. Its the skywalker foam plane that is gaining some popularity especially with the FPV crowd. It seems really stable and a big pussy cat to fly.
Anyway I have a few, probably quite basic questions, on s
Dear All
Hi, does version 2.6 support RC aircraft's with with four channels. The reason being i will be using the Apprentice 15e RTF. If not how do i modify the code, or even better does anyone have a modified code?
(please excuse my "noob" or "outrageous" que
Greetings,
Can anyone give me a rough idea what payload this 12 foot Telemaster could reasonably handle?
http://www.hobby-lobby.com/12_foot_telemaster_arf.htm
The wing area is over 21 square feet.
I am thinking of using it to fly LIDAR.
Thank you.
Hi,
for my own Autopilot, I will buy the Venus GPS of Sparkfun. Does anybody have practical knowledge with this modul? Is it possible to connect the TXRX pins directly with the Arduino TXRX pins?
I also don't understand the binary messages, what do I
Hi,
I am building my own autopilot for my RC Boat. I am trying how to calculate a course between the heading given by the GPS and a final point. I tryed the sphericaltriangle but, it is very difficult. Are there any other ways to calculate the course
Good afternoon,
I posted this in another forum but I thought it might be more relevant here.
Any interest in the ArduCopter with an ArduPilotMega board with Wiinunchuch and Wii motion plus for IMU, a Ping sonar unit for hovering,and all motors, props,frame, wires, fo
I was wondering if anyone could point me to any ground station software that can run on linux? I am not seeming to find anything. I would prefer something were I can tinker around with it.
When I select "over Terrain" in the configtool, the altitude is getting weired numbers. But only when leaving the USA for setting waypoints.
Within the US, everything seem good, but I live in Switzerland and I would like to use the "over Terrain func
Read more…i will be expecting my quadrocopter to be wet (completely soaked in water) so should i use a brushed or a brushless motor?
If I am using the IMU is it necessary to plug the Ublox GPS into that board or can it plug into the shield? If I plug it into the IMU the IMU will get a solid blue but the shield and Ardupilot will continue to blink blue. If I plug it into the shield
Read more…I've been running the test suites and everything appears to be checking out fine so far. However I noticed that when I switch from manual to one of the two modes loaded by default in Ardupilot my rudder moves from center to about 30 degrees left. I'v
Read more…I'm building an Arducopter and am still deciding between these two tx/rx systems. The Turnigy seems nice that it has more channels and some knobs instead of all two-way switches. However, it looks like it has an 8 AA battery pack and would need mod
Read more…