"yup... been done before... june 2012
https://www.youtube.com/watch?v=OP15Jm57Hmk"

"binoculars form the north bondi RSL terrace might work too... and it has a bar ;)"

"You can print a lot with 1kg of filament. While the mark up does seem excessive... the cost is still pretty low! e.g. the parts for gimbals would be ~ $1. Time is the real cost with 3D print IMO."

"my $500 solidoddle 2 has been great! compared some prints with my mates replicator 2, and while they have slightly better resolution... it's hardly noticeable and functionally parts do the same thing! if you want to dip you feet in at a cheaper cost…"

"thought he already owned an airline!"

""GPS based RTL inside steel girder bridge, what can possibly go wrong?" 
from the footage he started a fair way (500m+) away from the bridge... looks like he was taking off in front of the waterfront restaurant to me. DJI still have the…"

"looking good! what motors are they?"

"No, the flight controller (OpenPilot Revolution) is hard mounted on the bottom plate with the motors. The Revo doesn't get effected by vibration the same way the new firmware of the APM does, so no need to isolate it. I was planning on building a…"

"http://youtu.be/EI1I0UsC5l8"

"high cg? not really... battery is almost level with the props (especially if they have shafts)"

"@ruwan - around 10mins on a 1000ma 3s. Hovers at 1/3 throttle, so think it should be able to take fpv gear and mobius"

"Really like the top section for Möbius and battery. I was planning on putting battery underneath, but I might borrow your idea !"

"Nice. Been building something similar myself. Current body takes OpenPilot but was planning KK 2.0 and APM variants. Designing the extra hard points for video at the moment !
http://www.thingiverse.com/thing:158809"

"My rctimer arduflyer has out lived my 3DR APM 2.5. Never had a problem with them or their gear."

""You need at least 2 meters if you need to have onboard camera(s), OSD, Telemetry, etc...."

what a load of rubbish... never seen a TBS Caiprainha ? 85cm..."