I have finished building up my x quad up to an x8 coax configuration. I found the diagram for wiring the motors as per the Wiki for APM 2, and have double checked the actual motor wiring by listening for the esc beep as I disconnected the motors 1 b
Xbees are configured, talking fine via x-ctu. Re did my wiring again taking out osd and connecting directly. I get the following SEE SCREENSHOT. FTDI cable direct to xbee and usb to xbee rx -nothing, fine when connected x bee via usb. WTF?
Anyone have an easy way to reinforce GPS on apm 2.0? I ask because when I was flying my quad at the local golf course (nice soft grasss to crash on:), I did a hard bank and the velco star gave and my battery popped loose ( new strapping coming now)..
Group...So I am still having xbee issue on the drone side, I remembered I connected the usb while connected to the xbee to check the firmware update and load a pid setup file, it wouldn't load through xbee. Is this normal? flight planner disconnecte
XBee Issues with DIY adaptor problems. I am using a "roll my own version" using the same 900mhz parts as listed in the telemetry kit on DIY drones. I would have bought the kit is it was available, but well... I went ahead and ordered my xbees from d
I can't get this quad tuned if my life depended on it and need help. I know I am not the only one. Apparently there are several books written on PID tuning, thats great, but I am so busy replacing props trtyng to tune that I can't do this anymore. I
I have a witespy x4 550mm with 1020 Kda outrunners running 10" x 4.5 3 blade props. She flew perfectly using a Naza controller out of the box. I pulled the NAZA after 5 almost perfect flights and have installed my APM 2, and I definately need to t