About

Gender

Male


Location

Winston Salem, NC


Please tell us a bit about your UAV interest

AP platform.


Hometown:

Winston Salem


Activity Feed

Kenneth Bailey replied to Silvio's discussion 3DR GPS uBlox LEA-6
"I'm at a loss here. I have tried ever way to search for this and can not find any info.

I have a APM2 with built in mtech gps. I want to replace it with a ublox, is there any information on the forums explaining if this can be done and how ?…"
May 15, 2013
Kenneth Bailey replied to Ben Thomas's discussion I've tried everything on here but it still wobbles and flips on takeoff.
"My problem is, quad wobbles and flips immediately after leaving the ground.
 
 
Lower pid's....
 
This is common with high pid's. Drop them till it stops. Should fix it.
 
Ken
 
 
 
 "
Sep 13, 2012
Kenneth Bailey replied to Glenn M's discussion Crius ALL IN ONE PRO Flight Controller v1.0
"Oh ya, if you get one of these......be really careful with the usb port as you can rip it right off the board. Been there done that.

Its pads are to thin to hold it to the board and the designer has admitted it needs revised. Says next revision…"
Sep 12, 2012
Kenneth Bailey replied to Zen's discussion Deleted Posts, Censorship, and Content Manipulation
"pffft, shut up and fly !!!


:)"
Sep 10, 2012
Kenneth Bailey replied to Kenneth Bailey's discussion Heli Video's with APM2 ??????
"Wow, thanks guy's , very very nice.

Ken"
Aug 12, 2012
Kenneth Bailey posted a discussion
I have tried to find any video's with heli's flying on the APM2.Have I looked in all the wrong places ?Any links showing it flying with it ??Thanks ,Ken
Aug 11, 2012
Kenneth Bailey replied to Kenneth Bailey's discussion Octo yaw drift
"No ideas huh :("
Jul 28, 2012
Kenneth Bailey posted a discussion
Hi,I have AP OCtocopter with new APM2 on it. It flys great in stable mode except it drifts bad in yaw directions. Right or left does not matter. It feels most like its not locked in.Motors/props balanced, checked motor directions as per the…
Jul 27, 2012
Kenneth Bailey replied to Sean Estelle's discussion Payload Questions
"For a bit of lifting and the possibility of MAYBE surviving a motor or esc death , a octo might be your best bet.

Theoretically you can loose one motor and still fly her. It's been tested and works but .........

My Octo uses 2826 1000kv motors and…"
Jul 23, 2012
Kenneth Bailey replied to Sean Estelle's discussion Payload Questions
""Eat at Joes"   :)"
Jul 23, 2012
Kenneth Bailey replied to John Ess's discussion Tilt & Pan IP Camera for Autonomous Drone
"Hi,

I tried to find the video your talking about but was unable. Can you post the link to it ?

Ken"
Jul 23, 2012
Kenneth Bailey replied to Will Snodgrass's discussion Multi drone comunication
"I like that, any time news sheds good light on our projects is a good thing.

ken"
Jul 22, 2012
Kenneth Bailey replied to Zipharius Rice's discussion Assistance Needed! 3DR radio setup for telemetry
Jul 20, 2012
Kenneth Bailey replied to Sean Estelle's discussion Payload Questions
"How much weight we talking about ?

My octo lifts 4 lbs at the moment."
Jul 20, 2012
Kenneth Bailey replied to HesH's discussion Not sure what sensors do??
"This question is in the wrong thread don't you think ?

Should be in the hardware section.

:)"
Jul 20, 2012