When I plug the battery in and power up arduPilot with shield and the arduIMU connected, the IMU lights rapidly flash like normal, but after they are done, the yellow led does not come on.....if I unplug the yellow wire connecting d8 on the IMU to d6
I plugged my motor in on my Hawk sky and turn it on and it was working fine, but the prop was turning the wrong way. So I switched the two black leads and the motor was turning the right way, but then all of a sudden smoke came from out of the engine
On this page......... http://code.google.com/p/ardupilot/wiki/SolderingBoard it says I can solder a wire from the arduPilot shield to the positive terminal of my battery connection to send the batteries life back to the ardugroundstation. Bu
I have a hawk sky for my UAV platform, but the motor mount and the opening for the power and ground cables to go down through the plane to the ESC is so small that when I connect the motor, I can't get all the wires down into the planes fuselage. Is
I have flight gear installed, I have the ArduFlight_247 code running on the arduPilot and I am using a arduIMU. I have made a mission with the Config tool download and I have downloaded the arduFGcontrol1.1 file..... But can someone give me a step by
I have this setup running. I have arduPilot with blue arduPilot shield along with ublox gps and arduIMU. In fly by wire and stabilization mode without the blue arduPilot shield, these two modes work perfectly. However, when I put the shield on the a
When I did the SVN update today with my arduIMU software, in labview when the arduIMU is connect, it no longer is printing out the pitch and the yaw and all the other data needed for the 3D cube to work properly. All it is outputting in the serial wi
Hello, I would like to know everything I need to have an onboard video camera that transmits the video live down to a laptop or some sort of screen on the ground while the plane is flying. I am assuming I need the ramsi osd and then any kind of camer
Anyone that has this setup running, the arduIMU with a UBLOX gps directly connected to arduIMU, please give me any information you can on satellite locking, what you did when you had errors. I cannot get my gps to lock. Anyone please post your experi
The arduIMU is loaded, all the baud settings are correct, but no matter how long I wait, even in open sky, the blue led on the arduIMU board will not light up to show that the GPS has a lock. I don't know where to go from here. Isn't there a testing
Ok. This is what I have setup. I have the arduIMU v2, the ftdi cable, and the newest ublox from the diy drones store. After I hook the gps up with the cable to the arduIMU and then power it all with the ftdi cable, then I run the labview and the util