Gender
Male
About
Location
Porto Rafti
About Me:
Just interested in UAVs
Please tell us a bit about your UAV interest
Interested in UAVs and anything that has to do with flight in general.
Hometown:
Porto Rafti
Activity Feed
"Steve : wise choice, going for the APM 2 will make things easier.
Luca : upload the 2.7.1 and also d/l the config tool global. and we start from there"
Luca : upload the 2.7.1 and also d/l the config tool global. and we start from there"
"Finally I found the problem , it was my faulty jumber wires............
Thanks Tassos"
Thanks Tassos"
Hi I just set an ardupilot as per the wiki and I was trying to have a simulated flight in xplane (with servos connected) in order to test the setting out but I am getting a strange behaviour.The throttle seems to be interconnected with the elevator,…
"Makes sense, cut comms, drone goes into RTL mode, fake GPS signal to spoof landing site."
Is there a way that arduImu V3 can be used with ardupilot (legacy) as a replacement for arduimu V2 that is no longer in production?Thanks in advance Tassos
"Well the reason I am asking is that I am fixing my own tracker and I was wandering what servos to use in order to be compatible with the ardustation software. I tried last night with a modified 360 servo and the ardustation would not open the lcd,…"
"Hi do we need normal servos for the pan tilt or modified ones for 180 or 360?
Thanks in advance
Tassos"
Thanks in advance
Tassos"
"HI can you please provide a link for the diy Frsky mod for the 9x?
Thank you in advance"
Thank you in advance"
"hell why one of these birdies can't crash in my backyard , I need a new flir camera ;)"
"Skywalker and FPV168 are essentially the same planes with different materials, I would choose the skywalker since it is easily fixed after a crash and stay away for any kind of fiberglass since it is very sensitive to crashes.
Tassos"
Tassos"
ok it might sound silly but I finished putting together the ardustation but I have no means of testing it since I have no ftdi cable and no xbee yet, so here is my question, what we are suppose to see if we power the ardustation for the first time…
"ok problem solved, xtreem board was badly soldered and soldered was in the header resulting in bad contact.
After resolder it , I had already updated the xbee firmware to 1061, that firmware will not work with my xbees, so when I reflashed with 1002…"
After resolder it , I had already updated the xbee firmware to 1061, that firmware will not work with my xbees, so when I reflashed with 1002…"
Hi I have 2 xbees pro 900 (the 60mw?) along with an xtreem bee adapter and a usb adapter from sparkfun.The xbees are set as per instructions with 1061 firmware .Yesterday I tried for the first time to have them communicate with each other but I had…
"Hi is this tracking system compatible with APM 2.x or only with APM 1.x like ardustation?
Thanks in advance
Tassos"
Thanks in advance
Tassos"
"Ok , I keep reading everywhere that if your video tx is at 2.4 and your radio Tx is also at 2.4 you will have interference, problems , reduced range etc. why is that? I thought thats why we use 2.4 tx because of no interference, if you first open…"
Hi I was wandering what is the difference between Xbee 900 XSC and Xbee 900, which one should I use for telemetry? Thanks in advanceTassos
