"Thanks Leonard and Cala!
Changed my damping pads to moon gel and got less vibration on the X & Y but not that good on the Z. Checked all wires and any possible components that can transfer vibration thru the APM. Still, the problem exists. Any…"
Thanks! I thought it was still on the vibration limits. Pardon my ignorance, but what do you mean by as I put PID loop if I may ask? I strictly followed the wiki regarding vibration dampening using kyosho zeal. Should I use the 3M foam…"
I am too is experiencing this problem. Has anyone solve this yet? I used to fly AC 3.2 on bigger quads and flies smooth in all modes. Then I recently purchase the fat phantom shell 425mm from infinity hobby and installed my other APM 2.6…"
"Came across this thread and now finally enlightened as to why my copter suddenly lost altitude on Position Hold mode. But how come Marco Robustini's demo of POS hold doesn't have this problem? He was using a F450 frame I believe. So, was…"
"Thanks for the insights. It's not that cheap though, you can get for 800-1k USD. DJI store sells it for $999 maybe because of the lightbridge 2 release? How much did you get your LB1 if you don't mind?
How about OSD and manual gimbal…"
May I ask why would you not buy it again? I was thinking of buying it, however I came across a lot of owners getting dissapointed with it. Thought of getting the LB1 because it's cheaper now.
I am using Pixhawk with AC-3.2 on my…"
How did you connect the lightbridge RX to the Pixhawk? Is there a special cable bought online or did you DIY a cable for it?
Also, if I'm using let's say a Futaba 12fg Tx, can I still use all of its channels even when connected…"
"Alright!!! Nice work Randy and the Dev Team!
Randy, Does this include "Follow me" mode like the one in the Iris+?
Droidplanner 2 has brought back the follow me feature on it's latest release,
"Thanks Wessie, BTW, I am using tiger motor MN3508 580kv with Dji 15x5.5 carbon props. Everything is good and well on ecalc, until I change for 11000mah lipos and add some payload. My throttle mid on apm was 535 average on hover. With my new lipo and…"
"Hi Wessie, I am using Skywalker Quattro esc, and while in loiter mode I suddenly lost control of copter and when I saw my HUD there's no current draw, it is zero. Good thing props are still rotating and land the copter not quite hard to damage…"
Yes, you are correct. Flew my copter today again, no problems in all modes, still can't figure out what happened about the loiter crash yesterday. Nothing is damaged though. Still Learning to diagnose from logs. Will still post a…"