"IIRC there's one US distributor in Boston. I contacted him a few years ago on small production quantities (100) to ballpark some pricing. At that time, the 8x8 was about $100 each. The 32x31 was shiny new and ran close to…"
"While you want to save the copter, your REAL concern is the DLSR. So, considering the issues with whole copter recovery, why don't you look at the other end? Build an impact resistant (plastic and styrofoam) shell around your DSLR. Mount that…"
"I had to reread the exerpt again for this to make sense. Normally 802.15.4 based mesh networks work well in the city where they can hop data down the line. This is for more isolated areas, but allow them to use the same technology. The key here is…"
Not a beginner to robotics, but a beginner to RC aircraft. Working on both a RepRap to build custom plane parts and the idea of a single board IMU to drive or fly the first itteration. Took plastics engineering and aircraft dynamics back in college, and I do electronics on the side. Industrial motion control is what I do in real life.
Please tell us a bit about your UAV interest
No comments yet!
You need to be a member of DIY Drones to add comments!