"You say that "power port ground is NOT (connected to) the ground of the main output ports on the Pixhawk board"Also, above your diagram you state that there is "Ground isolation between power port and PWM ports on…"
" Bill Isenberger Do you have any evidence other than your story about what was found on your board by some unnamed person.Isn't that your second board ?
Didn't you also damage your first board?Kendall at UAVOBJECTS…"
"Hi Reuben, I did not have anything heavy attached to the F1000-M8 as I was initially trying 3 different motor sets with various prop combinations. In hindsight I am now aware that I had the same issue when using 3.1.1 in loiter on an RCT800 Hex, a…"
"Hi Randy, thanks for all the work you and the other developers have put into AC.I spent the last few days battling a pendulum like effect on an F1000-M8 Octa in Loiter on APM 2.5.2 with AC 3.1.1, had real bad pendulum effect and if hit by a…"
"I have a proposed fix for the APM2.5.x 3.3V regulator issues herehttp://www.rcgroups.com/forums/showthread.php?t=2053670&page=100#post27214895Texas Instruments is the only manufacturer, we are all in the same boat with this issue."
"Hi Randy, thanks for all the hard work you and all the developers have put into the project.I just loaded rc8 on a hexa that I will test in the morning>I did strike an odd thing when performing Accel Calibration, when told to place on Left,…"
"No I haven't performed those tests, I would suspect that YES there would be a difference.My initial Auto Tune tests were done starting with stock PIDs on which I had altered only Altitude Hold P and on some Loiter PID
I had to alter…"
"HK Talon Hexa 1100KX CF 9x5 4s, no camera
HK HAL Hexa 1080KV CF 9x5 4s, I am not sure if it had a Camcorder installed.
None of those are with a brushless gimbal, either a small Lunix or a 400 gram Panasonic HD Camcorder strapped under the…"