• Blog Posts
  • Discussions (2)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Juanjo's Discussions

APM 2.5 + Hardware Problems.

Started this discussion. Last reply by Juanjo Jan 11, 2013. 2 Replies

In a APM2.5+ purchased in December 2012 I installed the latest driver "ArduCopter-2.8.1.zip" in the "APM 2.5" using the Mission Planner desktop utility ("MissionPlanner-1.2.29.msi").The system does…Continue

 

Juanjo's Page

Latest Activity

Juanjo replied to Juanjo's discussion APM 2.5 + Hardware Problems.
"Sorry for my bad English. I have installed FW Quadcopter OK.After restarting the APM2.5., ABC LEDs are off.In the startup process fails the pressure sensor, altitude  (MS5611-01BA03)."
Jan 11, 2013
Peter Chaffe replied to Juanjo's discussion APM 2.5 + Hardware Problems.
"I didn't quite understand what your saying.. Go to firmware, install FW of choice. Then to set it up you need to connect..."
Jan 10, 2013
Juanjo posted a discussion

APM 2.5 + Hardware Problems.

In a APM2.5+ purchased in December 2012 I installed the latest driver "ArduCopter-2.8.1.zip" in the "APM 2.5" using the Mission Planner desktop utility ("MissionPlanner-1.2.29.msi").The system does not work. After installing the latest driver and connect to Mission Planer desktop will not let me set it up.Through the terminal I did a test of all sensors, all are correct, except for the case of the pressure sensor (MS5611-01BA03), which does not show any results,enclose a copy of the screen. …See More
Jan 10, 2013

Profile Information

Please tell us a bit about your UAV interest
Quadcopter

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service