"I have had a fair bit of this lately but only after MP updated to 1.3.32 recently with FW 3.2.1
I been having bouncing and tipping till the props hit... a few times I experienced the props spin up as well before the pixhawk works out it is crashed.…"
"I've noticed that following a flip over, the aircraft seems to continue flipping over on subsequent take off attempts, as if it's trying to resume its previous position. I've started disconnecting and reconnecting the battery if I…"
"I would not mind being the lead tester on the solo.
POV from my face camera has made it very easy to prove machine malfunctions that are not caught in the log. I am on Iris #3 all due to machine failures.
There is something going on that…"
sorry to post so late to this thread,
But this is an amazing idea! I've actually been looking for this exact concept so I may use a smaller case to transport both my Y6 And Iris+.
Have you have the chance to test the legs out?
"Make sure you lower your throttle to 0 when initiating RTH or Auto Land and let the flight controller shut the motors down. When you move the stick down and to the left, especially on unlevel ground, the copter thinks it's still flying…"
"Relying completely on GPS can cause problems if the GPS does not work anymore ;)
During my traditionaly helicopter days it was good habit to have one finger constantly on "throttle cut" if some stick movements went wrong and the vehicel…"
"I have seen mine land and then the motors spin faster before it figures out its on the ground. I can imagine with more power it would bounce. I've taken to simply putting the throttle at zero in stab once on the ground and leaving it until it…"
I love robots and Drones and MACHINE VISION
Take the soldering iron out of UAV equation. (make it modular)
Make the machines avoid things fleshy meat bags
Make the machines fly indoors.
2 hours of flight time with a payload.(I have no idea how to do this)
No comments yet!
You need to be a member of DIY Drones to add comments!