Hi, I am trying to setup up a decent develop environment for my ArduCopter.Because the Arduino compiler+debugger is kinda basic i am trying to work on it with the Eclipse.Did anyone use is before? I…Continue
Hi, Although ym DIP switch is in X mode when i switch from Stable to Acrobatic it changes from X to +. Does is on purpose? I double checked that i don't have any mixes in my Futaba RC ThanksMaayanContinue
DataLogging for APM1 Hi, For a while I wanted to record my flights for analyzing it later. The problem was that the current recording system is not working well. So I decided to rebuild the whole recording method.The first problem was to determent what parameters/variables I need…. I came up with this list:Servos InServos OutIMU:…See More
"With APM1 there are two choices:
Internal resistor (added)
They are mutually exclusive. #1 OR #2.
When using the AttoPilot you must add a 3 pin header to the APM1 and connect as shown in the Wiki..and below.
"I know those links but nothing is working according to the instructions in the wiki, i have only one 3.9K resistor soldered on AN0 (ground). I've connected the voltage/current sensor to AN1 and AN2 (voltage and current).
Hi, I've been through all the threads here regrading this issue and could find a solution :(I bought the Attopilot current sensor from Sparkfun:http://www.sparkfun.com/products/9028 I added the 3.9Kohm resistor in AN0 (and only in AN0) and i can't get the reading right. I am getting 0.63V-0.64V (correlating to 12.5V in full battery) in the Mission Planner. I check the voltage that comes out of the sensor and its somewhere around 7V. What's…See More