Nathan Martz
  • Male
  • San Francisco, CA
  • United States
Share Twitter
  • Blog Posts
  • Discussions (2)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Nathan Martz's Discussions

The Mysterious Case of the Dead PDB

Started this discussion. Last reply by Martint BuildYourOwnDrone.co.uk May 13, 2012. 1 Reply

I recently finished my first quad and have been practicing flying. At the end of my session today, I tried one last take off, something went wrong (probably due to a faulty motor) and the quad…Continue

Tags: 3dr, failure, pdb

Advice on Motors and/or Prop Swap

Started this discussion. Last reply by Martint BuildYourOwnDrone.co.uk May 13, 2012. 1 Reply

Hey, everyone. I'm super new to building and flying quads and would love some advice on a decision I have to make.I just finished building my first quad. It's a 3DR frame, APM 1, with 880kV motors…Continue

Tags: noob, 12x45, 880, apm, 3dr

 

Nathan Martz's Page

Latest Activity

Nathan Martz commented on Knut Graf's blog post Building a 3DR-B... found a frame orientation issue
"I ran into a similar issue when I built my first 3DR quad a couple weeks ago. In my case, the 4 wire ESC control cable from the PDB to the APM had totally different colors than the one referenced in the 3DR instuctions. I had to cross reference the…"
May 13, 2012

Distributor
Martint BuildYourOwnDrone.co.uk replied to Nathan Martz's discussion Advice on Motors and/or Prop Swap
"Hello Nathan,   I would drop down to the 10" props and stay with the 880Kv motors, you have not said how much your take off weight is, however I would not use 12" props unless I'm looking to lift over a 1.2Kg's. I would fit…"
May 13, 2012

Distributor
Martint BuildYourOwnDrone.co.uk replied to Nathan Martz's discussion The Mysterious Case of the Dead PDB
"Hello Nathan,   That sounds very much like the fault one of my customers had on their APM 2 board, and it was a fault on the board and not something he had done to it, I would look to contact the store you bought it from and see if they can…"
May 13, 2012
Nathan Martz posted discussions
May 12, 2012

Profile Information

About Me:
Full time game developer, fascinated by flying robots.
Tell us a bit about your UAV interest
Long time fascination with UAVs, especially now that they are getting affordable for almost anyone. Lots of respect for Arduino and ArduPilot. Just starting to build my first quad (3DR kit) and excited to be part of this community.
Hometown:
San Francisco

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Social Networking

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here

Groups

Advertisement

© 2013   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service