zhexiong shang
  • Male
  • Lincoln, NE
  • United States
Share

zhexiong shang's Groups

 

zhexiong shang's Page

Latest Activity

zhexiong shang replied to zhexiong shang's discussion Ugcs with inspire 1 takeoff and landing problems in the group UgCS
"I update the latest firmware and check if there is error message before each flight. As I remember, the reason I didn't use the UGCS APP to takeoff is because there is no automatically takeoff button exists after the APP is connected to the…"
May 29
Sergejs Bovtramovics replied to zhexiong shang's discussion Ugcs with inspire 1 takeoff and landing problems in the group UgCS
"Dear Zhexiong, Thanks for Your interest in our software! We suggest you to check and calibrate the barometer of the vehicle. In addition, it is important which is surface where the drone is going to landing. The asphalt surface is suitable for…"
May 26
zhexiong shang replied to zhexiong shang's discussion Add building KMZ file error in the group UgCS
"I believe so. Thanks."
May 13
zhexiong shang added a discussion to the group UgCS
Thumbnail

Ugcs with inspire 1 takeoff and landing problems

I just got my first flight test using ugcs with inspire 1 yesterday. I follow the previous post that first uses the DJI GO to takeoff the craft and then switch to ugcs and do the planning works. It works fine with all the waypoint and POI tests.But I found a problem when I try to land the craft because the landing gear cannot be switched back to the correction position. It seems that ugcs DJI app cannot control the attitude of landing gear of aircraft. Then I switch back to the DJI GO APP it…See More
May 13
Alexey Dobrovolskiy replied to zhexiong shang's discussion Add building KMZ file error in the group UgCS
"Hi,  models generated using Photoscan can contain hundreds of thousands of polygons, and UgCS can't process such models.Please try to reduce number of polygons in models.If this will not help please send your model to support@ugcs.com,…"
May 9
zhexiong shang added a discussion to the group UgCS
Thumbnail

Add building KMZ file error

I am struggling with how to add building from KMZ. I developed 3D model with agisoft photoscan and export it as KMZ file. Then, do the process as mentioned in manual to add this model into ugcs by browsing the file located in my same computer. However, I still not able to make it work.In one case, it just fails to add the model and the error message says: the request timed out.In the other case, (with different model source), it passes through the process but after I close the window I…See More
May 9

Profile Information

Please tell us a bit about your UAV interest
mapping modeling monitoring
Hometown:
cs

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service