I came across a website with freeduino, and as far as i can see its 100% compatible with arduino, and from the pictures it also looks 100% the same as arduino? So whats the point of it if its the same thing, just a different colour? I was just wond
Read more…In our project we separately generated pwm for each motor by using 89C51.How to control these four motor simultaneously using RC?
I just bought a Zippy Flightmax 2200mAh 3s1P 20C battery from HobbyKing. I have a Spektrum DX6i controller, and I was wondering if anyone could tell me whether or not this wire(_Male_Kokam_2S_10cm__(5pcs/bag"">http://hobbyking.com/hobbyking/store/uh_
Read more…Folks - meet "Controlling Access to Stored Information" - US 6,370,629, and a snapshot of my brain in 1999 when I filed it originally. It is the culmination in a process which produces non-repudiated controls as di
Read more…So my guess is that if I want to use ailerons, I just use a y-cable and plug it into the rudder output on Ardupilot. This rules out any mixing while under RC control but that isn't such a big deal.
Read more…Is there a simulator with ardupilot that can be used to test (GNC) algorithms on the desktop before going in for a flight test?
I saw uav playground but there is no update on using with ardupilot yet.
Any directions would be helpful.
thanks,
sujit
Hi I just want to start my UAV from zero!
Hello all,
Hi everyone, I was wondering if someone can post some sort of guide to the UAV Dev Board. Also I read in this article - http://diydrones.com/profiles/blogs/a-newbies-guide-to-uavs that it doesn't support GPS waypoint nav, has this changed?
Thanks,
JP
Read more…I want to work on an electronics tray for my Telemaster.
I'm considering buying a Predator from Verticalhobby but I don't really now what engine I should use. I'm not all that interesting in flying this by my self since it is supposed to be an autonomous vehicle in the future. I'm looking for something pre
Read more…Hi! I'm starting work on an unmanned boat, idea is to comb an area in a fixed pattern for some research work. Any ideas of a good autonomous computer? I would need to be able to update waypoints mid-trial, hence ardupilot does not look like it will w
Read more…I tried all the eight debugging steps, but the error persists.
My arduino board works perfectly with the latest FTDI drive, but with DIY FTDI cable I have this error:
So I will try to use an Usbasp AVR programmer to replace the bootloader with AV
Hi, I have a FMA Co-pilot 2. is it possible to use the sensor's with ArduPilot.
Is it possible to use an OSD Pro (EagleTree) by itself without the GPS. It seems like it should be better to use the same feed from the ArduPilot GPS. Can this OSD be used with just one GPS Rx? Also, is the eLogger needed in the system? I just want a
Read more…Hi all,
If any of you are building/flying an Aeroquad, Mikro has just released Shield Board Ver 1.6 for the Arduino 328 board. It is available in the Aeroquad Store for $24.95 plus shipping.
Regards,
TCIII
Read more…I finally worked up the nerve to maiden my radian test bed in autonomous flight. I though if I lost a already mangled airframe it would hurt so much. Although the flight was not a gleaming example of success I did perhaps cure some of the butterflie
Read more…I saw a post about connecting the output of Futaba FASST receivers to Autopilots, and grabbing the whole data stream.
Could anyone tell me what is the best way to send data from ArduIMU+ (non flat) to another board? I'm not sure about how to do that.
