"In Canada the rules from Transport Canada are simple, UAVs must get out of the way when a full sized aircraft is heading for the UAV. Not really sure how there can be a discussion? Why on God's green earth would an rc pilot not yield to a full sized…"
"Frank. The only thing I tried was to go back to 3.1 but the quad flew terribly. The impact made contact between the PX4 and a water pipe. Not sure if the PX4 is toast. Will do a few more tests first.
Thanks for your update.
"Thanks Randy! Always good to know exactly what caused something. Would a full recalibration be ok or should I hold off on trying 3.2 on this PX4 again?
"Hope someone can shed some light on this issue as I really want to get in the with 3.2...just not like this. :-) Well this is what the test quad was built for and adventure was had by all."
"Here is the log. Found at least three errors: Flightmode 4, Failsafe Fence 1, AFE Fence 1. I attached the log. BTW, I never invoked the land command.
2014-06-12 14-26-34 16.log"
"Never know, I was in stabilize mode. Will try to get the logs if I can, PX4 is beat up pretty bad. Copter hit an overhead water pipe in my studio. Might sound insane to test inside but imagine if this was outside! Yikes!!!"
"Well.....that was scary! The copter dropped, sat on the carpet idling motors not responding, was about to try to get the battery unplugged and the went to full throttle and smashed into the ceiling!!!!!!!!!!!!!!
First time any of my Arducpter craft…"
"Just loaded 3.2 via mission planner onto my test quad with a PX4. Only test hovered inside but copter has become ultra twitchy. Anything that has to be change upon installation for a DJI 450 size quad frame?
3.1 was perfect but I really want to try…"
"$7000 all up will get you one of these. I use it for commercial panoramas as well so gps is fine. And you can lift a lot if you need to. The only reason I use a DJI FC on this one is for simple angle changes at each coordinate otherwise I would have…"