"Chris, I don't really care,,

My biggest gripe with you, and all 3DR, is that, when you buy a 3DR product, you have just unwillingly signed yourself up to the unofficial 3DR R&D team....
and from all the comments above, nothing has changed with the…"

"OMG you are kidding me..

I'm not going to go any further than say...  you're dreamin buddy"

"I've just returned to the world of 3DR after a much needed break from it,,

I just don't get it???  you guys still have Randy bangin away at full speed trying to re-invent the wheel and some new EKF thing???    and then,,, you release the solo...  …"

"yep understood..

no worries,, cheers"

"you're a legend!  

cheers..

will be good to compare

BOB"

"Can anyone add their Parameter file from a succesfully flying Trex500/550 sized heli with Pixhawk...
I'm going around and around in circles adjusting these settings, but getting no-where...  would be great to see someone else's settings...  

Thanks…"

"Thanks Rob,, did my first flights yesterday with Pixhawk on T500, I actually opted for 3.2.1 for fear of loading something with issues,,,

I have a few tuning issues,,
1) I can't get the tail to stop waggling,, even with every yaw setting as low as…"

"Hey Rob,, so about to start a new Trex500/Pixhawk,,  just read this thread from start to finish,, all sounds like good fun,,,,  can I use RC7 safely?? have all those bugs from RC5 and RC6 been resolved??

or should I just use 3.2.1??

Cheers BOB"

"HI Rob,,,  can you have a look at my crash thread 
http://ardupilot.com/forum/viewtopic.php?f=21&t=6780
It may be the same problem.. I have logs and video of a crash during landing approach,, and you can hear the motors "hunting" a bit,, right…"

"Hi Leonard,

I tried AT on my new Pixhawk powered Tarot960 Hexa for the first time yesterday, before AT the Hexa was very jittery as standard settings too high,,,

after autotune, (very successful) Hexa flew great! so disarm with AT still on,, to…"

"Are those files for Pixhawk though??
Mine works great on FrSky TFR8SB Rx"

"I had same problem, as it turns out I have to power the output side of Pixhawk with another reg,, as I'm using Multistar OPTO ESC's,, and Pixhawk only has 0.9V on output side...  as soon as I powered the output side,, it works...

Welcome to the 3DR…"

"Thanks Bill,, yeh I was just a bit concerned as the standard cable uses 5 wires,, at both ends,, but that might be just because the DF13 port is a 5 wire port,, and they just bought a truck load of 5 wire DF13's??"