"Is it possible to get a binary of this? Ideally for pix hawk. I have built for APM but the servos seems to move incorrectly.
Any help would be most welcome as I have an air frame I cannot get airborne.
Thanks"
"Use an airspeed detection of around 4m/s. Disable all others. No throttle delay. Launch in Auto Mode.
Works a treat, never had a failed launch over 18 mnths. Remember prop safety though don't arm the pixhawk till just before release.
"This looks like the code I have been searching for. I'v been trying the coax and single copter builds for Pixhawk and APM but they are limited and very out of date.
Where can I find the source code for the Caipirinha config? Will this compile with…"
"That's an exact description of the behavior I see, yes. I give it a try and let you know how it goes. Though the device definitely was not giving this anomaly when first installed. "
"Mine developed a lot of glitching. Randomly giving zero height but only momentarily and has never caused a false landing event. Thus far!
I really like this unit though - it is indispensable to get a decent landing with a large RPAS."
"The number one rule is carriage of LiPo is as cabin baggage where the hazard can be dealt with.
Lipo's for drone must not ever go in the hold of the aircraft."
"Well, lets have a conversation about what the differences between these systems might be.
I'll volunteer to put my neck on the chopping block and start that conversation............
My understanding is this maybe something like.
"This such a wonderful forum for people working with drones and agriculture and across all levels of that space. Let's be wary of bashing each others efforts, we all share the same core interest after all.
IMHO."
"Sorry to jump topic Michael, but while I have your attention, I'm busy trying to get alternate lanes to work in Mission planner but it seems to be broken! I'm assuming Its my duff grasp of how it works as usual!
Any advise on how this works? Its a…"
"I you want to upload a param file we can see if its set OK. I still struggle with bitmasks if in doubt just enable cam logging in isolation and work from there.
Let me know if you need help to set this."