Gender
Male
About
Location
Sydney
About Me:
RC Enthusiast.
Activity Feed
"Nice find. I like the look of that product."
"I would have thought it would be more than just fitting the maths to suit the cable diameter.
Maybe something with ultra low resistance like superconducting wire."
Maybe something with ultra low resistance like superconducting wire."
Cyphy has popped up again...http://www.northeastdronenews.com/start-cyphy-works-developing-high... sort of technology is involved in getting 1000W through a filament thinner than headphone…
"Anything rounded that you add to a flat frontal surface has to be better than square."
"@The Sun
Everyone here is posting unsubstantiated numbers. What's wrong with another opinion?
Garry McCray has a post above that seem to make very good sense, are you going to call him on those numbers. Fwiw I think Garry's numbers reflect my…"
Everyone here is posting unsubstantiated numbers. What's wrong with another opinion?
Garry McCray has a post above that seem to make very good sense, are you going to call him on those numbers. Fwiw I think Garry's numbers reflect my…"
"Do they have bills like this for general camera use, because it's pretty much the same, it just flies a bit higher."
"@Jeff,
Do you normally fly in Tv mode with auto aperture?
What are the recommended settings?
Our photos from 69 meters are ok, but they are not as sharp as I think they could be.
Thanks"
Do you normally fly in Tv mode with auto aperture?
What are the recommended settings?
Our photos from 69 meters are ok, but they are not as sharp as I think they could be.
Thanks"
"Thanks Krzysztof. I'll take a look,
Best regards
Matt"
Best regards
Matt"
"Hi,
Is this doc still available?
Thanks
Matt"
Is this doc still available?
Thanks
Matt"
"Can I ask how you got APM and mission planner to trigger the photos?
We have tried to get the trigger to work at waypoints and it didn't work.
Also, do you have a log of your nag course? How strait did your plane have to fly for this?
Cheers
Matt"
We have tried to get the trigger to work at waypoints and it didn't work.
Also, do you have a log of your nag course? How strait did your plane have to fly for this?
Cheers
Matt"
"Looks like it needs at least double the power..."
"Not sure if its relevant, but I lost altitude significantly on a flight whilst following the Navigation Tuning instructions.
http://code.google.com/p/ardupilot-mega/wiki/Tuning
"2. Start with the NAV_ROLL I and D terms and the Crosstrack Gain all at…"
http://code.google.com/p/ardupilot-mega/wiki/Tuning
"2. Start with the NAV_ROLL I and D terms and the Crosstrack Gain all at…"
"Does the camera triggering work in Arduplane 2.7?
We can't seem to get it to function."
We can't seem to get it to function."
"I made contact directly with FRSky and they had the following information.
So all that would be required to support the FrSky receivers would be an option in Mission Planner config to accept 0-3.3v or 0-5v (or some Zero to other-voltage-value) …"
So all that would be required to support the FrSky receivers would be an option in Mission Planner config to accept 0-3.3v or 0-5v (or some Zero to other-voltage-value) …"
Hi,I have FRSky which seems to output 0-3v for their RSSI, whereas APM 2.5 code seems to use 0-5vI'm not a programmer, but I can see it would need a small code tweak to rescale the 0-5v range to 0-3 by multiplying it by 0.6. Correct?Optionally, it…
