I am very new to this but I have done a bit of reading prior to making this, my first post.I am sorry for the insane amount of config information I am about to list here but from reading post after…Continue
I know this is old but did you have any luck getting your drone working on auto? I'm resurrecting a project that is similar to your's although mine is a track vehicle but uses the same controller and motors and the Pixhawk. I…"
"Daniel, Has this been resolved? Did you disable the brakes from the motors? I had similar experience with yours. Without knowing about the brakes, I kept burning the 40A fuses. After taking out the brakes, everything went well. When the rover moves,…"
"Just received my Reach kit in the mail. Nice to see that they took the time to get nice packaging made up for the devices. The devices are much smaller and lighter than I expected. I have not touched or configured them yet. I am going to wait until…"
I did put an amp clamp on one of the motors.
Without pegging the throttle I was able to determine that current during normal travel across pavement or grass did not exceed 10 amps. The peak was actually 7.9 amps. If I purposely stall the motor…"
It sounds like you have completed all of the right steps in attempting to troubleshoot your issue in the Auto Mode.
The fact that the chair does not run smoothly sometimes in the Manual Mode may indicate an issue with the calibration of…"
This is my first Pixhawk build.Pretty much have a Jazzy wheelchair subframe set up in skid steer.Using a 2x32 Dimension Engineering ESC in "independent channel" mode.Using a low cost 6 channel E-Sky radio and receiver.I can successfully drive the rover around with the RC controller....sweet!!BUT...today I attempted my first autonomous test.....FAIL :(I set up a very simple Home to Waypoint #1 scenario and switched to Auto mode.The rover turns to face the way-point but when it should begin…See More
"Okay you have won my support. I have just sent my support payment and hope to see wonderful things from you guys over the next couple of weeks. Please post videos of your integration progress with APM & Pixhawk platforms as you make…"
"This is precisely what I have been looking for!
But I have to say with all honesty, and no intention of causing any bad feelings , this whole Indiegogo thing is something that is really alien to me. As the consumer, how are we protected? This is one…"
I am very new to this but I have done a bit of reading prior to making this, my first post.I am sorry for the insane amount of config information I am about to list here but from reading post after post I always find an experienced member always asking for it anyway. I will oblige to help...so here we go.I have a PX4 running ArduRover 2.49 and MP 1.3.25I have an inexpensive 6 channel Exceed CT6A RC radio and receiver. The radio was configured in Heli120, Mode 4. The channel mixing performed in…See More