Jimmy Prouty
  • Male
  • Maize, KS
  • United States
Share

Jimmy Prouty's Friends

  • Justice Bentz
  • Ray Anderson
  • Nitin Jain
  • Harry Tuttle
  • Dean Walker
  • Alain
  • Wrongway
  • jim C.
  • Ole Martin Gladhaug
  • Anish
  • Paul Mather
  • Robert Krogh (hooks)
  • Dean

Jimmy Prouty's Groups

Jimmy Prouty's Discussions

Help with Y6 Setup/APM 2.6

Started this discussion. Last reply by Jimmy Prouty Nov 3, 2014. 1 Reply

APM Elevon Mixing Problem

Started this discussion. Last reply by Jimmy Prouty Jan 26, 2014. 3 Replies

 

Jimmy Prouty's Page

Profile Information

Please tell us a bit about your UAV interest
hangar18uav.com
Hometown:
Maize KS USA

Jimmy Prouty's Photos

  • Add Photos
  • View All

Jimmy Prouty's Blog

First Flight of Hangar 18 F2

Posted on May 16, 2013 at 1:00pm 2 Comments

Hangar 18 had a very successful first flight of the new F2 prototype on 14 May.  

The new…

Continue

Foamaroo Spin Tests

Posted on March 13, 2012 at 10:00pm 9 Comments

We're continuing to fly the Foamaroo and are constantly amazed by what it will do.  I wanted to try using a flat spin as a failsafe/abort system for the plane and actually tested by spinning it until it impacted the ground.  My suspicions were correct - I was able to pick up and relaunch the plane after every flat spin and impact.  Only damage was a slightly loose…

Continue

Foamaroo First Flight

Posted on April 25, 2011 at 10:01am 13 Comments

 

We had a very successful flight on the Foamaroo prototype yesterday.  The Finished airframe came out at 2 lb 11 oz complete with 2200 mAH battery.  It was windy yesterday with 15 know winds and the Foamaroo handled the conditions very well. 

 

After a short trim flight I was able to launch the plane with a single handed toss and was happy to see…

Continue

Low Cost Jackaroo Under Development

Posted on March 24, 2011 at 7:00am 8 Comments

Hangar 18 is pleased to announce that we have a licensing agreement with AttoPilot International to develop and produce an FPV version of the Jackaroo UAV. The new airframe will be a lower cost version that is designed and built with the FPV enthusiast in mind and will feature lower cost materials to let us pass the savings on to you. Please e-mail us at…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service