KnutL
  • Male
  • Bremen, Germany
  • Germany
Share

KnutL's Friends

  • Gerrit Oehlmann
  • Michael Pursifull
  • GillesW
  • John C.
  • James Goppert

KnutL's Groups

KnutL's Discussions

Battery Monitor: Cannnot enter values

Started this discussion. Last reply by KnutL May 17, 2012. 12 Replies

I am using the APM1 built-in voltage sensors and try to calibrate it.APM Planner 1.1.84 does not allow me to enter any value.I set Monitor= 3: Battery Voltage, Capacity=3000 And then I try1. APM…Continue

RadioIn = 0 all channels

Started this discussion. Last reply by KnutL Oct 18, 2012. 8 Replies

After a long winter break I wanted to make my first flight in 2012 with my easystar and APM (after having more than 50 flights with the same equipment in 2011)   During the initial ground testing I…Continue

 

KnutL's Page

Profile Information

About Me:
Software, Hardware and flying: Thats the game.
Please tell us a bit about your UAV interest
Planes and copter, in future fpv...AP in any case
Hometown:
Bremen

Comment Wall (1 comment)

At 4:58pm on November 20, 2010,
Developer
James Goppert
said…
Hi Knut. Here is the link I used: http://qgroundcontrol.org/dev/start Also be sure to check out my APM mavlink branch, most of the code should just work after you tweak the interface to the underlying autopilot variables.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service