• Male
  • Oak Ridge, TN
  • United States

climr's Groups

climr's Discussions

Flight instability when switching from guided to Alt hold

Started this discussion. Last reply by climr May 5, 2016. 1 Reply

In a recent flight I had flown about 10 minutes in a combination of loiter and guided. While the aircraft was in the middle of a guided leg, I switch to alt hold.  The aircraft immediately started to…Continue

X8 Motor Output, shoud it be balanced?

Started this discussion. Last reply by leonardthall Apr 6, 2016. 49 Replies

Just built a large/heavy X8 config running 3.3.3 - 12 pounds and 17.5" props. Tiger 80A ESC and KDE 360 kV motors.On the initial flight test the X8 would yaw left without input and even at full yaw…Continue

Altitude jumps in loiter and alt hold but not in guided

Started Nov 19, 2015 0 Replies

When in alt-hold or loiter, the craft is jumpy about the vertical axis. If switched to guided, the craft is rock solid. You can see this in the attached log analysis looking at one of the motor…Continue

Integrated camera options, what is out there?

Started this discussion. Last reply by Joseph Douglas Sep 19, 2015. 1 Reply

Hi everyone,I am looking to tightly integrate camera systems into my platforms. Looking for success stories or product recommendations.Requirements:Must take power from the platform (no separate…Continue


climr's Page

Profile Information

Please tell us a bit about your UAV interest
Autonomous Flight
Oak Ridge, TN

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service