Ramon L
  • Male
  • Vega Baja
  • Puerto Rico
Share

Ramon L's Friends

  • Trent at MyGeekShow
  • mahmood

Ramon L's Discussions

APM connects randomnly to Mission Planner and after a second stops responding

Started this discussion. Last reply by Ramon L Nov 13, 2011. 2 Replies

Today I was flying my Quad and went to take off, pushed the throttle up just a little to make the props spin and then after more input the quad was not responding... Went to repeat the process but…Continue

Brushless Motors (All about info. request)

Started this discussion. Last reply by Ken Dec 15, 2010. 2 Replies

Hi to all!I'm looking for a webpage where i can find information about brushless motors, information like: How to obtain the best thrust vs. prop dia. vs. current consumption.Info about the BL motor…Continue

Help! need a technique for desoldering on my ESC

Started this discussion. Last reply by Ramon L Nov 7, 2010. 4 Replies

Actually Im wornking on 4 TNY Plush 30A mods! but I have a question for someone who wanna help me in this... Im trying to desolder the voltage regulators but i think my technique is not working... I…Continue

 

Ramon L's Page

Profile Information

About Me:
Ex Giant Scale RC Pilot , Aerospace Eng. student. 13 years of R/C experience
Please tell us a bit about your UAV interest
ArduCopter in process...Already building the electronics and modifying ESC's
to work on I2C. Learning the basics and complexities!
Hometown:
Vega Baja

Ramon L's Blog

New Align APS ( Auto Pilot System )

Posted on May 22, 2012 at 10:08am 15 Comments





Align Helicopter APS system features:



1.Semi-autonomous take off / Landing (Activate system, semi-autonomous takeoff into position and altitude hold, hovers in attitude hold with strong holding ability to prevent drifting, suitable for hover and flight…

Continue

Propeller Balancing Tutorial

Posted on April 18, 2011 at 12:38pm 3 Comments



I found this video to be an excellent tutorial for prop. balancing and wanted to share it. Hope it help a lot of our members to solve vibration issues etc.

 


"...I dont work for horizon hobby and i'm not saying or encouraging to buy products from this distributor..." before some one jumps and say something... lol  :)

 

A Brand New Propeller Deisgn

Posted on April 17, 2011 at 9:37pm 12 Comments

Well just as the tittle says, a new design is out and looks great, hope to see some of this props on the 9'' , 10" , 11" and 12" dia. size. 

For more info. here is the full article.

http://www.flyinggiants.com/forums/showthread.php?t=63180

 

As we all know when…

Continue

New Lithium Titanate Batteries the perfection of Li-po

Posted on February 21, 2011 at 7:28am 32 Comments



The very low internal resistance of the Batteries (typically 8 – 10 milliohms) give huge benefits such as:

  • Far longer battery lifetimes with upwards of 1000+ cycles expected for a battery pack.
  • Lower heat build-up during the discharge cycle.
  • Faster cell recovery.
  • Lower voltage drop under loads, which equates directly to a much higher RPM per volt from your electric motor.
  • More available power for the battery…
Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service