Gents I need your help.I recently upgraded one of my 2.6APM powered quads to a Pixhawk. One of the reasons I went ahead and did this is because the Pixhawk is supposed to take PWM RSSI signals…Continue
"Hi, I am struggling to make ezuhf to work with fixhawk(rctimer pixhawk). But can't see my rc inputs over msn planner. Looks like the fixhawk board is not listening to the rx. Is there any step by step instruction for making it work with ezuhf…"
"Hi,I followed all the instructions here, thank you for that. I got closer to solvemy rssi problem.
If I switch the transmitter off my rssi will only get 50% instead of 100% why? I did the "raw rssi" but the values do not match the 0% and…"
Because ArduPilot hasn't been able to understand RSSI via a PPM channel, many users of EzUHF with MinimOSD found themselves forced to use a passthrough via the channel directly to the MinimOSD to get RSSI. This meant that while you…"
I'm trying to only show the rxRSSI information (from the ezUHF) on the Mission Planner HUD.
Do you have an idea why i can't see it? the info is in the PPM stream at ch8 as usual.
"I use various FRSKY receivers with all my Pixhawks... all work perfectly including on 3.3 RC7
Note that the X8R sends telemetry back to the Taranis... In some cases if the X8R receiver is too close to the your GPS, you may get less satelites as the…"
"OK all is working now :) If I re-read the thread from the beginning, I would have noticed one nice little detail that Steve Cain put in an earlier post:
"1) this works with 2.4r727... not the earlier releases"
DOH! I tried…"
"I've been at this for 2 days now with no luck. 3DR Iris+, Arducopter 3.2, MinimOSD Extra 2.2, EzUHF 1.5.
Using APM with Arduplane this configuration works, no problems. On Pixhawk/Iris+ and Arducopter, all data for osd is coming through except…"
"Well, it shouldn't ... but it does. SR2 had to be set already for me to have any data on the minimosd. The only data I was missing was RSSI, when everything else setup correctly. I really get no RSSI data when I don't set that…"
"It shouldnt matter.
The SR0 -> 2 values are how frequently various groups of telemetry values are sent from the FC out on the telemetry port. Naturally if no data is going out the Minimosd has nothing to report and draw."
"I would like to share my story to get this to work. I followed everything in this thread with no success so far. Until today.This might help other people as well.
I was struggling with getting EzUHF RSSI to work on MinimOSD-extra. Today I got…"
"I had looked in Mission Planned a few times with no luck, it must have been sticking in my face. I remember looking at the param's at the four major flight controls assignments which are the very next ones. DOH!
Funny, the first time I…"
"Oh! well I am glad you found what you needed.
You would think it would be on the flight mode screen, right? But noooooo way.
Just to recap for others, I changed the flight mode channel under config/tuning under the full parameter list. Look for…"