• Male
  • Neuss
  • Germany

Gregmaan's Friends

  • Andre
  • Marco Robustini
  • Andrew Tridgell

Gregmaan's Groups

Gregmaan's Discussions

Heavily oscillating RCOut for motor 5 and 6 on large Hexa

Started this discussion. Last reply by Gregmaan May 21, 2015. 1 Reply

I have some strange behavior with my new build T960 on 3.3 RC4: Large oscillations on RCout but only on RCO5 and a bit less on RCO6 which suddenly stopped in this log. I am using Arris 5010 12 pole…Continue

Pixhawk and Sonar for Arducopter 3.1.1 RC2

Started this discussion. Last reply by Gregmaan Feb 15, 2014. 2 Replies

Hi,I did a post in the new forum, but I did not get any further response:…Continue

Use of EGNOS instead of WAAS in Europe

Started this discussion. Last reply by Michael Utz Dec 10, 2012. 2 Replies

Hi,did anyone changed the DGPS function to EGNOS instead of WAAS to get a higher GPS accuracy in Europe?I thougt I should only change line 45 in…Continue

RCX_DZ Parameter lost afer reboot 2.65 and 2.66

Started this discussion. Last reply by Gregmaan Nov 14, 2012. 1 Reply

Hi,having some problems setting up second aileron on RC5, I found another issue:RCX_DZ parameters for the trim deadzone are always lost after reboot APM 2.I used firmware 2.65 and 2.66 programming…Continue

Tags: Zone, Dead


Gregmaan's Page

Latest Activity

Gregmaan replied to valentin colon's discussion pixhawk memory corrupted in the group PIXHAWK
"There are only two options: SD Card or Pixhawk.... Take a new slow formatted SD card .... If this doesnt help ...Flash Pix with another firmware (Rover, Plane, e.g.) an then back to Copter e.g. In second case, don´t forget to backup your…"
Jan 21
Gregmaan replied to Michael Berthelot's discussion GPS Module malfunction in the group PIXHAWK
"HI, in the meantime, the GPS is configured automatically, by the pix with an actual firmware and there are plenty of status messages through mission planner. You can diag the module with the ublox u-center in an passthrough mode or with a serial…"
Jan 18

Profile Information

Please tell us a bit about your UAV interest
Arducopter, Arduplane

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service