• Male
  • maastricht
  • Netherlands
  • Blog Posts
  • Discussions (33)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Wolfgang's Friends

  • Rob_Lefebvre

wolfgang's Discussions

APM2.5 with HV servos ?

Started this discussion. Last reply by Rob_Lefebvre Aug 4, 2013. 2 Replies

Hi,looking for info on how to connect HV servos to APM i couldnt find anything.So, here (in attached jpg) I present my best guess of what i should be doing...Does this look correct ?any comments…Continue

Tags: servos, HV

big altitude changes although the aircraft sits on the ground

Started this discussion. Last reply by wolfgang May 29, 2013. 3 Replies

Hi,a few days ago i started experimenting with the takeoff-waypoint.first flight was ok, but since then i have a good chance that the value for altitude is corrupted before takeoff (although i have…Continue

Tags: gps, altitude


Started this discussion. Last reply by wolfgang Feb 25, 2011. 1 Reply

Hi everyone, from what I understand, this parameter will increase the throttle value slowly as required up to my throttle_max setting, rather than going instantly to throttle_max when switching from…Continue

the influence of wind

Started this discussion. Last reply by wolfgang Feb 25, 2011. 2 Replies

Hi,I tried to tune parameters for the last weeks, had 20+ flights and didn't get anywhere. My plane keepsI have just the basic APM, no airspeed sensor, no compassI am using a Multiplex Cularis (2.60m…Continue

Tags: wind


wolfgang's Page

Profile Information

About Me:
i fly rc helicopters, gliders, acro, anything.
tried nightflying, tried fpv, will try autonomous flying
Please tell us a bit about your UAV interest
mainly to get my gliders back home safely, in case i went too far with the thermals

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service