The pesticides storage tank in spraying drone need indignation on low tank volume. I have digital water sensor which is been places to the bottom of the tank, It will change the logic level 0 or 1 depends on the presence of water.
Can I use any of the
Read more…I first posted this in Unassigned, but it wasn't getting any traction.
Hi All,
I have been chasing jello in my video for about seven months now. Somewhere along the line I've introduced a new vibration problem that I don't understand and haven't been a
Read more…I m making a racer drone. I am using 2300kv motors. Whenever i try to run them they dont run properly. Some motors spin, some donot, some stop automatically, some spin at slow speed, some at correct speed. And also i m using 30A ESC.Anybody can help?
Read more…I need someone to upload the stock flight controller firmware and parameters files for a open source Cheerson CX-20 quadcopter. I installed Mission Planner from Arducopter and, like a bull in a china shop, I accidentally let it UPDATE as soon as it
Read more…Hi All,
I have been chasing jello in my video for about seven months now. Somewhere along the line I've introduced a new vibration problem that I don't understand and haven't been able to fix.
In addition to the typical jello that is caused by prop/mot
Read more…Title says it all. I want to upgrade the antenna on my M8N Module. Can anyone recommend an antenna around the $100 mark. I am looking to reduce multipath interference while increasing positioning accuracy.
Read more…Hi All! We are Cyberfreak a group of Entusiast Diyers and Makers just aproching the Drone Panorama.
We recently bought a Erlecopter with erle brain, supporting Apm and other fancy ubuntu stuff :)
Actually we are facing a problem that doesn't allowd to
Read more…Hey guys ive been doing alot of reading about ardupilot and the pixhawk the past couple weeks and have alot of questions. Most i am answering through searches but, i wanted to ask this one in the forums.What all can you do with a companion like a ras
Read more…...This is my 1st attempt at the racer. I have an APM 2.6. I have all my calibrations as requested on the Initial Setup...
I need a stable platform because it only goes up to my GEO FENCE and sits until I turn off the Tx, in which case it RTL as a Pre
Read more…Afternoon!
First off I'm very new to the world of drones as you'll probably find out by some of the questions I'm about to ask. So for a school project we are building an autonomous drone that will do certain tasks. We decided to use a Navio2 flight
Read more…I am having an issue and am not sure why it is happening.
I switch flightcontrollers from librepilot revolution to the pixhawk. I also have the 915mhz telemtry radio other those 2 things everything on my quad is the same. I am running a frsky xjt mod
Read more…What happened to this screen?
Clicking on the simulation tab in Mission Planner (currently 1.3.41), this screen is now replaced with what looks like the window that would open after clicking "Start SITL."
As it is right now, it appears the there is no
Read more…Some of the top 10 drones for under $500 on Amazon - http://dronebusinessmarketer.com/top-10-drones/
Read more…DroneMapper is very pleased to announce that RAPID for DJI is available for download and testing on limited imagery data sets at no cost to the user. RAPID will provide scaled DEMs and orthomosaics using up to 75 images for a scene. Results are avail
Read more…Hello all!
I'm looking for advice on the closed loop mode of BLHeli ESC firmware with regards to Arducopter.
The benefit of the closed loop should be better control performance of the attitude control, but there could be a number of side effects...
For
Read more…Hi
I am using a pixhawk3.3.3 with a quad. yesterday I was flying in altitude hold mode, suddenly quad flipped and drown into a pond. I couldnt recover pixhawk, esc and battery. out of four motors two were good and we couldnt check other two. ther
Read more…Many people don’t know what should they buy for DIY a quadcopter? And how to DIY a quadcopter which can flight longer and higher? Now I will tell you how to DIY a quadcopter like this .
Next I will tech you how to DIY a large quadcopter, what do you n
Read more…Nitro Planes has discontinued this model. Is there anyone out there who bought the kit but has second thoughts and wants to sell. I would contact the Chinese factory if I had the contact info to see if they had some left in some corner of a warehouse
