Gender
Male
About
Location
Porto
About Me:
www.aeropixel.net
Please tell us a bit about your UAV interest
Photogrametry
Hometown:
Porto
Activity Feed
"This post is of incredible importance for writing from A to Z in a single page everything that matters to aerial photogrammetry!Bookmarked! Thank you very much!"
"It's easy.Lower your throttle min value to less than 950 pwm, then rebind the receiver with your transmitter.
After rebinding reset your throttle min value to the original about 1100.
That way when you turn off or lose radio signal, you'll enter…"
After rebinding reset your throttle min value to the original about 1100.
That way when you turn off or lose radio signal, you'll enter…"
"What are you using to communicate with your APM? A Raspberry Pi?"
"Sad to see you go Rob! The end of your support will be noticed hard, but Family always comes first!I wish you the best of luck with your life!
Thank You!"
Thank You!"
"What are your magfield readings now?Try to consider anything, like e.g. a nail in the stick, or something metallic under that wooden floor.Move that stick and have always an eye on that magfield. Take the antenna from that stick, and see if it…"
"Like that user said, his canopy magnets were the culprit.
Battery alarm creates also an important magnetic field, I found that out recently.In mission planner you can experiment the mag field live by going to Flight Data > Status tab and then watch…"
Battery alarm creates also an important magnetic field, I found that out recently.In mission planner you can experiment the mag field live by going to Flight Data > Status tab and then watch…"
"You're welcome!"
"I've had also the same problem yesterday after upgrading the firmware.It was very anoying, and the more I tried to solve the problem, more errors came up, like the "Bad AHRS" on top of the "Error Compass Variation".The only solution was to reset the…"
"Hello friends.Howcome in an plane APM there isn't the option to set rc6, rc7 or rc8 as RTL mode like there is in copter?I wanted to set RTL mode on a 2-position switch as a "panic button" instead of using it on the traditional flight mode rc5…"
I was searching around on Hobbyking when I've found out this interesting "Turnigy Redundant Dual 8A UBEC Rx Power System", and was wondering if this could be used as a safe UBEC to power the servo rail of my plane's…
"Thank you Mario.We're looking forward for your post on MAPIR!"
"I agree with Marcin and Thomas.
The Skywalker X8 is simply too big to be just hand launched.
In my first trials and I almost got it ruined in the front and in the wing joints. A disaster. I decided to make a ramp catapult, but sincerelly, it's far…"
The Skywalker X8 is simply too big to be just hand launched.
In my first trials and I almost got it ruined in the front and in the wing joints. A disaster. I decided to make a ramp catapult, but sincerelly, it's far…"
"Congratulations.In the end, did the LiPos survived or got busted?"
"It powers the APM, that important.
I guess you MUST read all this first before you proceeding with anything else.
http://copter.ardupilot.com/wiki/introduction/"
I guess you MUST read all this first before you proceeding with anything else.
http://copter.ardupilot.com/wiki/introduction/"
