Gender
Male
About
Location
Kenosha, WI
About Me:
Avid rc modeler and electronics hobby tinker. I like fabrication and robots.
Please tell us a bit about your UAV interest
I'm trying this on a beginner scale level. Going to start with rc ground stuff first.
Hometown:
Winthrop Harbor IL
Activity Feed
"It is on mine.
It's a 1A 20v Schottky diode, pretty common part.
Keith"
It's a 1A 20v Schottky diode, pretty common part.
Keith"
It has been a couple of weeks now and I'm getting more comfortable with my STABALIZE and LOITER set up on my 3DR quad. Still having some yaw issues but yesterday morning I was enjoying the fruits of my labor out at my local RC field.In one of my…
"This same thing happened to me and was identified as a problem with an old helicopter radio I've had for years.
Turns out that the throttle potentiometer is worn out near the middle stick (hovering position). This would happen and I'd throttle back…"
Turns out that the throttle potentiometer is worn out near the middle stick (hovering position). This would happen and I'd throttle back…"
"Thanks for sharing. It looks good to me, but I'm courious if your rx is too close.
Something to try.
"
Something to try.
"
"Do you have a picture to share? That might help..
"
"
Another flight with the same problem. I removed the bullet connectors and cleaned up the wiring and removed the camera and transmitter, but I've got the same issue.Please reference the video link @ 0:43, 1:30 and at 2:45.I'm not seeing anything…
"Here in my area if you break something and make it unusable,
You have "Taco'd" it. ;>)"
You have "Taco'd" it. ;>)"
Like the Title says,I'd like to learn what each of the 76 selections mean.Most of them to me are obvious, but there are ones like: Logarithmic,Ing, ax, gx, mx, magfield, wpno, press_abs, and brklevel that I haven't got a clue. Thanks in advanceKeith
"Nice video!
I did my maiden Sunday morning and it didn't go very well. I'm trying to understand the recorded log file to see what happened."
I did my maiden Sunday morning and it didn't go very well. I'm trying to understand the recorded log file to see what happened."
"Nice morning today and noticed 2.5 was released, so I did a mission planner update to my new 3DR w/850kv motors and APM1. I think I followed the online manual to the "T" and headed out to the field for a maiden flight.
I put it in stabilize mode for…"
I put it in stabilize mode for…"
"Just thought I'd share some notes so far. I have it working with a seperate GPS module right now and editing the HappyKillmore Remzibi editor exe.
"
"
I have the 3dr quad kit and had a bad ESC, (still waiting on a RMA for two days).The other 3 work fine with my 2200mAh 3cell lipo's. But would like to use a 4cell A123 2300mAh packs instead. I know they are heavier but they have always been my…
"I'm courious what the requirements are for an ESC to work with the auto calibration?"
"I agree, What I'm trying to figure out is if there was any specific requirements that I should look for if I was to select 4 new esc's and not to break my bank. I'd like to get something local and available. Maybe some low model 20A Castle Creations?"
