"thanks for the Response Bill but i think Randy answered this question succinctly enough! the feature really does alot more than just adding waypoints, which i was aware of. "
"thanks Randy i was hoping you and your team were involved in it in some way and i could get a sneak peak earlier...ok i lied i wanna use those features NOW! :P thanks for the response Randy"
"Hello, with the CES 2016 Announcement of Multi point cable Cam and Follow Me Free Look, is that something that would be available earlier in Pixhawk as a flight mode as opposed to the SOLO App? thanks in advance…"
"Well Hello everyone, nice to be back in this old familiar forum! Sorry for the Intrusion, just wanted to say hi to all the people that taught me something about flight controllers and piloting during my APM 2.6 days. After a Tragic and Horrible…"
Anyone know of a Battery checker for a 3DR SOLO batter? with out a blance charger i do not know how to hook up the 3DR Battery to see if all cells are functioning. Currently on a fully loaded Solo (gimbal - Go Pro) flying in winds about…"
"in case any one is still following this thread, i did get some UBECs, i connected it to 12v power, then connected the Skids. i then checked the volt meter and was getting the proper volts to make the skids work....well one worked. three others did…"
"Does Any one know what this warning means? "CH8_OPT has more than doubled the last input. Are you sure?"
i am still struggling with Retracts on APM 2.6, i looked at Extended Tuning, Clicked the CH8 Options dropdown, saw two possible solutions, Mount…"
"This is a look at the multimeter. this reading does not allows the retracts to work. this is connected to the JST connections that come off the battery
on this Reading, the retracts work. this is connected to the receiver.
"yeah i ordered a few BEC to see if that does the trick. i know it works from the receiver, but i will separate the power source and just leave the signal connected to the receiver. i am also going to try the TLX8002 controllers by routing the signal…"
"i actually did buy the TLX8002 thinking the same as you but then later found out from the selller and manufacturer that only the LARGE of the Skids needs the TLX8002. The skids i have only need to connect to a 5 V source to make them work