Chris Latham
  • Male
  • Wollongong NSW
  • Australia
Share

Chris Latham's Friends

  • Luke Smith
  • Richard Evans
  • Harley Engholm
  • Tony Foate
  • Andreas M. Antonopoulos
  • Asaak
  • Chris Lovett

Chris Latham's Groups

Chris Latham's Discussions

Does vibration effect gimbal operation?

Started this discussion. Last reply by Maury Aug 15, 2015. 1 Reply

Hi all, I have mounted a brushless gimbal to my Quad. It is a HK gimbal found here, …Continue

Tags: mount, Gimbal, Vibration

3DR connection between PC and Module not working

Started this discussion. Last reply by Jim Pullen Oct 6, 2012. 1 Reply

Hi all,I thought I would throw up a post in relation the connection issues I had with my 3DR and the PC while using the FTDI cable. Straight out of the box I found (eventually) that the FTDI cable…Continue

 

Chris Latham's Page

Profile Information

Please tell us a bit about your UAV interest
FPV
Hometown:
Wollongong

Chris Latham's Photos

  • Add Photos
  • View All

Comment Wall (3 comments)

At 6:23pm on February 11, 2013, Harley Engholm said…

Hi Chris-Today I checked my throttle setting to hover and found that I am hovering at about 23% throttle, which is very low and well below the dead zone in the program. I have seen that when hover throttle is below dead zone, the quad will descend. I loaded the 2.9.1 firmware this afternoon and it appears that the throttle_mid is adjustable and I may be able to set my dead zone down where it belongs. I will post when I get the quad set up again and can try the altitude hold.

At 6:42pm on February 11, 2013, Harley Engholm said…

I am using 2832 1000kv motors and 3s 2200 batteries on an aluminum frame. If the dead zone adjustments in 2.9.1 work you might check to see how much throttle you are using to hover. It may well be below the dead zone also!

At 11:35pm on February 11, 2013, Chris Latham said…

I'm using 1200kv motors and 1, sometimes 2 in parallel, 3s 2200 batteries with a aluminum and craft wood frame. I'm having a bit of a play now with some settings and will see how it goes. Thanks for the reply. 

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Chris Latham's Videos

  • Add Videos
  • View All
 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service