Peter Koch
  • Male
  • Vienna
  • Austria
Share

Peter Koch's Friends

  • Crescent UAV
  • dineshguru.v
  • CyberCrash
  • Sebastian Gralla
  • Jason Short
  • Paul Mather

Peter Koch's Discussions

NEW ArduPilot Mega 2560 problem

Started this discussion. Last reply by staleva putra Jun 7, 2011. 38 Replies

Hi,I got my new ArduPilot Mega board this week and it has already the Atmega 2560 on it. So how do I get the ArduCopter RC2 code on that board ? I already selected the right board type…Continue

Futaba Serial Bus RX

Started this discussion. Last reply by Jake Stew Jun 5, 2012. 4 Replies

Hi,just would like to know if there is a way to connect the new Futaba S.BUS receiver via serial bus to the APM? http://2.4gigahertz.com/sbus/ regards,PeterContinue

 

Peter Koch's Page

Profile Information

About Me:
Flying models since 40 years and I am verry interested in this project
Please tell us a bit about your UAV interest
Quardcopters and Helicopters
Hometown:
Vienna

Peter Koch's Blog

My new octocopter frame

Posted on March 13, 2011 at 2:30pm 64 Comments

This is the new folding frame Project I am working on.

Can anyone tell me if it´s possible to control the eight counter rotating motors with ACM.

Comment Wall (1 comment)

At 4:40pm on November 14, 2011, John Campen said…

Peter, what was your final outcome on your X8?. Do you have any details of the setup anywhere I can look at? I just finished building my 8X coaxial quad frame and I am now looking how to set up the motor configuration on the software.How did you set up this for AD on the Mission planner software?

Also what was the best motor prop configuration you settled on? For efficiency I'm doing testing on using 1100kv motors for bottom motor and 850kv for top  and with slightly larger prop on the bottom. Not sure how easy this will be for controlling the direction though. My line of thinking is the faster bottom prop will pick up the slower moving air from the top prop and give it extra push as well it having a slightly larger prop will pull more air from the side of the down air column. Just theory at this stage, but seem to be some merit in this from a few of my first tests on my rig. Any advise you can offer would be greatly appreciated.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service