Chad
  • Male
  • Adelaide, South Australia
  • Australia
Share

Chad's Friends

  • TechSully

Chad's Groups

Chad's Discussions

Traditional Heli - Pixhawk Motor Interlock enabled

Started this discussion. Last reply by Chad Mar 13, 2017. 2 Replies

Hey guys, I think this maybe a common issue here but I have everthing setup with my radio (taranis) and modes all set with the 6 pos switch all good, just cannot get the this "motor interlock enable"…Continue

Pixhack error: Check BRD_TYPE: no lsm303d found

Started this discussion. Last reply by TechSully Jan 21, 2017. 14 Replies

Hey all, well its been a frustrating time here with the newly purchased pixhack. I purchase a genuine CUAV unit and was told I could run APM/PX4 stack with out any issues, but I simply cannot do it.I…Continue

Tags: Pixhawk, Pixhack

 

Chad's Page

Profile Information

Please tell us a bit about your UAV interest
Pixhawk, naza, love the autopilot stuff
Hometown:
Adelaide

Comment Wall (4 comments)

At 6:57pm on January 21, 2017, TechSully said…

Hey Chad... I read your thread at:

http://diydrones.com/forum/topics/pixhawk-error-check-brd-type-no-lsm303d-found

...and am having issues with the 3 Pixhawk Minis I purchased with the same issue you were having.  Have you been able to reliably use the Mini with Mission Planner.  I am a bit concerned and may have to purchase some "older" Pixhawk to complete my 3 ship project.

Thanks for any help you have!

Sully

At 8:15am on January 24, 2017, TechSully said…

Hey Chad,

I don't see the response I sent early yesterday.  Did  you not receive it? 

At 8:18am on January 24, 2017, TechSully said…

At 9:59pm on January 22, 2017, TechSully said…

Thanks for the info Chad!

 Are they going to send you a refund or another autopilot?  I sent an email to 3DR for an RMA for the 3 that I bought.  We'll see how that goes.

I have a 2.4.8 and may use it.  I'm build a few custom quads and done buying frames.  I built a CNC mill where I can cut my own carbon fiber plates.

Do you know anything about creating a flight plan that could fly to a waypoint, turn to an object, tilt the camera to a defined degree, trigger a camera via PWM signal, then turn and proceed to the next waypoint and repeat?

At 8:19am on January 24, 2017, TechSully said…

I'm not use to this forum... I posted it above.

Also meant to ask, what are you flying?

Thanks again Chad for your response.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service