Dr. Stewart Pid
  • Male
  • Lompoc, CA
  • United States
Share
 

Dr. Stewart Pid's Page

Dr. Stewart Pid's Blog

Fiberglass Easystar landing gear and fuse half joining.

Posted on March 3, 2010 at 12:32pm 15 Comments

Here the fuse halves are joined with masking tape and the inch and a half seam tape is applied to the bottom.

Landing gear being molded into the bottom and will be sanded smooth after resin sets. The long brush on top will be used to apply the seam tape to the inside top portion of the fuse.

Rear wheel temporary fit…

Continue

Easy Star Fiberglass Fuse

Posted on February 7, 2010 at 4:37pm 9 Comments

I'm in the process of making a mold for a easystar fuse. I used the replacement foam fuse from the local hobby shop and mounted it to a board, filled the pushrod channels and servo holes on the outside. Fuse plug is painted and waxed.

I must decide where to install hatches (if any). I still have the removable canopy as a seperate part, and will mold the wing insert seperately.

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service