"Make sure the sensor is really working when you connect it to your flight controller (try blowing into the pitot tube, you will see the changes in value of Air sped reading in mission planner, usually above 15m/s). Calibrate the air speed sensor…"
"This is analog air speed sensor. I tried using that, but I find the calibration very erratic. So I replaced mine with digital air speed sensor (white instead of black differential air pressure sensor), it's more expensive but more reliable"
"test flight a while ago, hovered it 3 meters away from me. My quad went to failsafe due to low battery. but instead of landing, it performed RTL instead of LAND. I thought it should choose whether to LAND or RTL based on hardcoded 5m rule? is…"
"by the way, I have performed current calibration prior to this by doing this method:
1.Fully charge your lipo
2. Immediately fly your multi for at least five minutes 3. Land and disconnect the lipo from the multi4. Immediately, charge your…"
"Hi! I did another test flight with my tbs discovery. I was a bit windy last day. but everything went fine. I raised my quad to 60m without problem, then raised it up to 100-120m and held it there for a few seconds then returned down and landed…"
"the copter responds to switching to stabilize in overriding the Landing sequence now if i use the flight mode switch on taranis. but when i use a toggle switch which i programmed to override the ch5 pwm, it does not work.. no switching from landing…"
"I will try to repeat this sequence later. I will fly it at around 3 meters again, then wait until battery failsafe kicks in. I just found it weird though because I have been using this "panic" switch to set it back to stabilize…"
"test flight yesterday went well. except for this:
copter triggers battery failafe then initiated auto landing. on the previous builds, I was able to override the landing by flicking one of the toggle switches on my taranis radio. that switch is…"
Is there a work around for my alexmos simplebgc gimbal? I was able to use it without issues on the previous 3.3 beta build. but now it seems I cannot control the pitch. Previously, i use ch6 on my radio. The gimbal was connected to…"