James Miller
  • Male
  • Nevers, Nievre
  • France

James Miller's Friends

  • Todd Hill

James Miller's Groups

James Miller's Discussions

Qgroundcontrol and mission planner compatibility

Started this discussion. Last reply by Bill Salopek Apr 30, 2019. 1 Reply

Beginner here. TIA for patience.I've configured my pixhawk flying wing with Mission Planner, and am ready to fly when the weather breaks, but need to use a tablet in the field. I'm wheelchair bound,…Continue

Tags: launch, auto, planner, mission, qgrouncontrol

No servo movement

Started Dec 16, 2018 0 Replies

Thanks to all for all the work and patience here.Tx/Rx: Graupner MX-20, GR-24MP 1.3.6AP 3.9All was well with my first AP setup of a flying wing Falcon. GPS worked, controls moved in the correct…Continue


James Miller's Page

Latest Activity

Bill Salopek replied to James Miller's discussion Qgroundcontrol and mission planner compatibility
"James did you figure this out? I'm wondering because I would also like to know if MP and QGC can be used interchangeably. Thanks..."
Apr 30, 2019

Profile Information

About Me:
I'm an aero engineer, sailmaker and pilot, (about 3300 hours, single engine land, IFR,, seaplane and glider pilot)retired and disabled (no legs) and as of 2016 a total newbie at arduino and APM. Learning.
Please tell us a bit about your UAV interest
RC modeler since 1960 (yes, that's a 6), with a long gap to go sailing (gone 14 years), then to France. Since legs went to the trash, went back to little airplanes. Legal Resident of France.
Paris for 15 years, then Nevers (central France)

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service