Jeff E
  • Male

Jeff E's Friends

  • Prasant
  • CarbonCore
  • Martin Szymanski
  • Sasha
  • Paul Guggenbuehl
  • Bart
  • Gordon
  • Hai Tran
  • Anish
  • Marianne Antonio
  • Michael Oborne
  • Scott Plunkett
  • Jason Short
  • Heino R. Pull
  • Bill Nesbitt

Jeff E's Groups

Jeff E's Discussions

Mission Planner option for INPUT voltage

Started this discussion. Last reply by Jeff E Aug 21, 2011. 1 Reply

Is there a way or is possible to be added on the mission planner to set this? # define INPUT_VOLTAGE   X.XXSo that correct voltage will show on ArduStation/Mission Planner without uploading via…Continue

Could this be a faulty ESC?

Started this discussion. Last reply by Jeff E Jul 20, 2011. 2 Replies

I recently bought from a local reseller here a complete kit of arducopter. It turns out it was an old model with 1280 board and now after soldering it seems the esc is damaged. I tried to swap…Continue

Clarification on MediaTek MT3329 GPS

Started this discussion. Last reply by Jeff E Jul 16, 2011. 1 Reply

I have this GPS from udrone. I tried the MTK Mini GPS to check the refresh rate and…Continue

Yaw problem 2.0.33

Started this discussion. Last reply by Jeff E Jul 9, 2011. 3 Replies

I found thread Yaw problem but I dont want to hijack his thread. I have pretty much similar issue with him having a…Continue

Tags: X4, FYETECH, yaw, 2.0.33


Jeff E's Page

Profile Information

About Me:
RC Hobbist
Please tell us a bit about your UAV interest
Aerial Photography

Jeff E's Photos

  • Add Photos
  • View All

Jeff E's Blog

Finally lifted with camera

Posted on September 6, 2011 at 7:37pm 2 Comments

Technically this is 3 frame with camera but the first one was hard to control, weight of GoPro with skeleton cover was too much for weak motors. 2nd one was stock ACM but ended in a crash with v39. Finally this was the only frame/setup can last long enough for me to take a video.



Comment Wall (3 comments)

At 7:20am on July 31, 2011,
Michael Oborne

Jeff, what number are you entgering for declination? just so i can test. all my test show it working correctly.

At 7:40am on July 31, 2011,
3D Robotics
Chris Anderson
I think he typed this in the status box by mistake: "I keyed in 0.13 (0deg13') then it will be saved as "-0.2200". I always change it to "0.2167". I know I can set "0.2200""
At 7:42am on July 31, 2011, Jeff E said…

Yes I did...was trying to undo and try to pm Michael directly..forgot to remove it...s

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service