Matt Ford
  • Male
  • United States
Share
  • Blog Posts
  • Discussions (6)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Matt Ford's Discussions

Turnigy KForce ESCs won't calibrate; U8 Motors won't spin

Started this discussion. Last reply by Matt Ford Aug 24, 2014. 2 Replies

I have an X8 with Tmotor U8's being controlled by a pixhawk. I originally had tmotor 45A SimonK ESCs on, but the U8's apparently don't like SimonK firmware. I had the copter off the ground with this…Continue

Pixhawk motor #6 doesn't spin

Started this discussion. Last reply by Richard Boyhan Aug 6, 2014. 3 Replies

Posted this on rcgroups too.I just finished my RC calibration on my Pixhawk X8. After performing an esc calibration, 2 out of the 8 motors didn't spin up. I tested every motor/esc individually on…Continue

Pixhawk + Futaba RC calibration issue

Started this discussion. Last reply by Matt Ford Aug 5, 2014. 1 Reply

I recently finished building an X8 multicopter with a Pixhawk and Futaba R7008SB receiver. After uploading firmware to the Pixhawk, I calibrated the compass, accelerometer, and tried to calibrate the…Continue

 

Matt Ford's Page

Profile Information

Please tell us a bit about your UAV interest
Currently building a large heavy-lift X8 multirotor with t-motor U8's, 29x9.5 props, and a Pixhawk
Hometown:
Boston

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service