"Marthinus said:
Marthinus said: I think the major problem that happened is that if I calculate the max amps that all 5 motors draw it is about 180amps and the power board can only handle 60 amps. If you add the VCC 5 volt supply to the Pixhawk to…"

"Glad you did it !
What is your AUW ?  4300 grams ?
I'm curious about how you attach the carbon tube with  motors , can you show a photo ?"

"I use the 2.0.25  version of Apm Planner 2 on Linux Mint  and Windows 7 64 .
The  available  32 bit version for Windows is not the latest and have some bugs."

"The graph was made with  Apm Planner 2
The Rc3 output shows full  throttle command to the Esc but you gradually go to zero Amps so I think it was the Esc"

"When you have switched to FBWA your battery was quite low just 3,4 volts per cell, than it drops to 17,4 Volts with 59A , so 2,9 volts per cell , a condition where Lipo batteries get damaged.



Then your Ampères went gradually, 4 seconds from 59 to…"

"I recently bought 3 Lidar and mount one on a plane with Arduplane software.
From my tests the Lidar on Arduplane 3.8.4 is only used in Land mode since in Auto mode the EK2_RNG_USE_SPD will prevent from my understanding the use of the Lidar since…"

"I wrote you a PM but got no answer.
Can you make an invoice ?
How big is the airplane box ?
Thanks"

"Buy a Mrobotics  X2.1 autopilot , it has 3 telemetry ports and IMO is more reliable than the Pixhawk Mini."

"1200 watts to hover , wow !
What is your AUW ?"

"The  Lw20 has a waterproof enclosure so it is not possible to solder wires to serial output , you have to send back the unit to a lightware assistance center.
I  did just a short test  with the  TF-mini , I do not like the fact that under 30 cm ,…"

"I recently bought three Lidars.Lightware LW20/I2C , LeddarOne and Benewake TFmini, the last two with serial connection .

The Lw20 has an interesting feature to drive directly a servo to scan and could be use for obstacle avoidance but beware , do…"

"Beware that the more big are the propellers the more difficult is to control their inertia.
Start with a smaller and most important with a lightest copter do some filming and then reconsider your project. t
You will probably find that flight time is…"

"Hello yangdaonline ,
Weight of the gimbal ?"