May i know the minimum wing span limit of mav in which the AP can be applied? hmmm... im trying for a flapping wing model...suggest me your ideas for controlling it...
Read more…Hi,
I have a futaba 7C transmitter.
Is it possible to program all 6 flight modes using two switches (2 state switch + 3 state switch) on this transmitter?
Thanks.
Hey all,
I know it's early, etc...but how does the GPS position hold work?
I'm using NG with Mtek and when I turn it on, I'm not getting any action.
Not really seeing much in the configurator or manual either...
I appreciate the tips!
JC
Read more…I have the pre-soldered kit. I cannot find anything to tell me how I power the APM and receiver. Each of the ESC's connect to the PCB, I think all but one should have the power wire cut? From the PCB I have what must be a two wire power supply, but w
Read more…I will apologize in advance for a double post, but this was buried in another thread and I need an answer.
Guys new to all this...
finally got round to building this thing
I have the APM set with the IMU shield all standard as it says in the how to list (I even got a skyfun)
I'm sitting here testing and it was all going well
was able to get to CLI and set
Read more…UPDATE: project page available at http://www.varesano.net/projects/hardware/FreeIMU
In the past months I worked a lot on accelerometers, gyroscopes and digital compasses. I'm now pretty intimate with the ADXL345, the ITG3200 and the HMC5843.
I've bee
Read more…Does that mediatek GPS that comes with the arducopter kit have the newest firmware? Or do we need to update it with this tutorial>>>>> http://code.google.com/p/ardupilot/wiki/MediaTek
When running the Airspeed test in the CLI what values should be displayed assuming calm ambient conditions? The following is similar to what I get and was wondering if this is normal.
0m/s
0m/s
0m/s
0m/s
0m/s
0m/s
0m/s
0m/s
0m/s
-17729m/s
0m/s
0m/s
-31699m/s
-963
Hi guys
Hey,
Hi,
Hello,
/p/ardupilot-mega/w/edit/MPDatalog from this server."Hello everyone,
I've just got telemetry added to my ardupilot and have a good working connection with the GCS software on my laptop. Is there a way to download a georeferenced map or imagery before a mission if there is not internet access at the fli
I am using a ArduPilot board with ArduIMU V2+ for pitch roll and yaw sensing. The default code processes roll, pitch and yaw (ground course) and sends it into ArduPilot. ArduPilot thus has RLL, PCH and CRS information reflecting the respective angles
Read more…Would anyone have the command line that could be used with avrdude to reload the PPM encoder? I've got an adafruit usbtiny programmer and avrdude, but I'm not sure of the command line version... I think I've decoded the fuse bytes, etc from the orig
Read more…
Hi everyone,
I'm new to the whole UAV thing, but I am very interested in flight and I have a fair amount of electronics knowledge and I program BASIC stamp micro-controllers to make ground based robots! I am only 14 and so I have limited funds and ti
Hello Guys,
Hello I got a pair of XBee modules all synced up and I´m ready to install the airborne one. The other one will show up as a serial port in Windows for use by the Configurator app.
Hello, I have "+" setup. From the artificial Horizon of ArduCopter configurator, pitch axial was fine, but left and right were the opposite. In prefly test, roll it to left, right motor power increased.
When I tilt up quadcopter, front moter power i
