Gender
Male
About
Location
Fremont, NE
About Me:
Have been in RC since 1960, now flying several helicopters and doing aerial photography.
Please tell us a bit about your UAV interest
Taking pictures of real estate, farm property, busines etc. I am now interested in the multicopters and want to build one.
Hometown:
Fremont NE
Activity Feed
"I read somewhere that the bottom ones need to be a little larger to overcome the prop wash from the top ones. Have you experimented with different sizes."
"What size props are you using, are they all the same size....."
It seems since going to 2.7 and up to 2.73 I am having uncontrollable glitches with the motors. I think I have isolated everything, no bullet connectors, checked the amperage draw of the 880 motors to see if bearings could be the problem.I have 2…
"I just tried my Tri-Hex APM 2.5 880motors and after flying steady for about 10 seconds, it just flipped over on its back, broke 5 props. I have been having intermittent glitches ever since 2.73 and the APM 2.5.....What is going on....."
"Does this address the wobble in loiter mode...........Don"
"I have the same problem, always resets to 0"
"I had the same problem and sent it in, the attitude was going all over the place as well. All they did was reload the firmware, I thought I had done that , but I guess not, works fine now.....Zdon"
I cannot see the drivers in Device Manager, have been through all the forums and cannot figure out my problem. I have Python 2.7 but cannot upload to my APM. Have been working this for days now. When I upload thru Arduino, I get "expected…
"I had the very same problem with my hex and 880 motors, there was no wind and it was hovering perfectly when close in, but as it got about 50 foot away, it seemed like there was not enough stick to bring it back and then letting go of the stick it…"
