The ARCHER GR8 FrSky receiver features the new ACCESS protocol. ACCESS provides the lower latency and increased performance of our previous G-RX8 receivers. With OTA (Over-The-Air) function support firmware upgrades will be very easy, no more wires.
I am close to the fun bit of my new build but am dismayed that I cannot find any folding propeller to fit the design at 1855. The thought of bolting props onto the beast every time I need to launch does not excite me.
I have a X6 hex, with a Tarot gimbal running firmware 1.5.
Sometimes I get pitch wobble in the video, which is not apparent on the hex. I have even had it after landing when the hex is completely still, so definitely a g
Well, I should have taken the advice of, pretty much everybody, and built a simpler model as my first build. But I didn't... I jumped right in and built a DYS D800 X8, and a Tarot X6 at the same time. I took the D800 X8 out yesterday for her maiden f
Hope one of you guys can help me identify a root cause to this accident here:
I have just finished a large hexacopter build (Tarot X6, 18" props, 325Kv motors), and on it's second flight, shortly after takeoff, it slowly started yawing left, feeling f
I finished my Tarot X6 960 frame that I will use for experimental purposes.
I need to open the upper plate to shorten some cables and I found that almost all of the M3 screws that go into the spacer are stripped because I used too much thread l
I have been troubleshooting my Tarot X6 960mm hex running Pixhawk, and cannot figure out why it is flipping on takeoff. I have reviewed a number of other forum topics, but can't seem to get a stable takeoff. Recent corrections/checks have included...
All of the Archer receivers are hyper-matched with the ACCESS protocol. They not only feature wireless firmware upgrades, increased range, and telemetry performance, the R4 now supports more functions like configurable telemetry power, S.Port/F.Port
FrSkyXact series coreless servos utilize all CNC machined aluminum protective case and metal gears, these servos are 8.4V high voltage capable and offer high speed and configurable torque performance. Also, the Xact series servos offer multiple form
Phase One Industrial together with Air Supply, a UAV Partner, will show you how integration with a Gremsy gimbal can keep you ahead with the latest technology.
FrSky Receiver TFR4SB is Compatible with FASST 2.4G: Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode) Finally an affordable S.Bus reciever. Not only is it affordable, but we offer improved sensitivity and stbility for better comunication
As a portable radio, the FrSky Transmitter X9 Lite is a remarkable fusion of traditional radio design with the innovations of the latest ACCESS protocol. The X9 Lite inherits its classic form factor from the FrSky Taranis X9D series remote control, a
The DJT telemetry transmitter module is a superb choice in case your transmiter is compatable using the Junior modules. (in addition to Turnigy 9x/FlySky 9x/EMAX 9x)
The Telemetry Radio System produced by FrSky offers an additional return link which i
Is it necessary to use low mah FS if I am using a Low Volt FS? I have my low volt failsafe set but the drone comes back and lands long before reaching low voltage. I think the low mah failsafe could be the cause. I would like to know if there is a do