Gender
Male
About
Please tell us a bit about your UAV interest
F550 looser
Hometown:
Wien
Activity Feed
"I hope soon sti iptv set top box cpu run arducopter code, sh4 sti7105.
Hardware mpeg4 support, gpio ports, wifi, lan,spi,i2c,nand,usb, 1ghz cpu ddr3 ram,.... and only one stream for all. video, control......"
Hardware mpeg4 support, gpio ports, wifi, lan,spi,i2c,nand,usb, 1ghz cpu ddr3 ram,.... and only one stream for all. video, control......"
"I think maybe motor,prop or esc issue
Firmware version?
Esc type?"
Firmware version?
Esc type?"
"esc-s beeping still you press safety button.
this is normal"
this is normal"
"You can install Rc10 in Mission Planner beta."
"Known issue maybe repaired in rc10."
"https://www.youtube.com/watch?v=LQkoOEMgM0w&list=UUPcCCiqkWYZmv...
Same problem in this video too.
Very possible your io board damaged.
https://groups.google.com/forum/#!topic/drones-discuss/rL2jE67fPeM
"Hi Marco, What receiver do you have…"
Same problem in this video too.
Very possible your io board damaged.
https://groups.google.com/forum/#!topic/drones-discuss/rL2jE67fPeM
"Hi Marco, What receiver do you have…"
"Pixhawk 3.1.5 equal with APM 2.6.
So Pixhawk software not released yet and I think do not release 3.2 this year(too much bugs).
Pixhawk hardware good but need 1-2 years to software use it."
So Pixhawk software not released yet and I think do not release 3.2 this year(too much bugs).
Pixhawk hardware good but need 1-2 years to software use it."
""Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear"
"Most modern RC receivers (and all…"
"Most modern RC receivers (and all…"
"R7008 cause freeze on Copter code 3.2-rc2 and latest master too.
Be careful when fly Pixhawk 3.2 in SBUS mode."
Be careful when fly Pixhawk 3.2 in SBUS mode."
"Dev site:
http://dev.ardupilot.com/
Build info:
http://dev.ardupilot.com/wiki/building-the-code/
Build howto:
http://dev.ardupilot.com/wiki/building-ardupilot-with-arduino-windows/"
http://dev.ardupilot.com/
Build info:
http://dev.ardupilot.com/wiki/building-the-code/
Build howto:
http://dev.ardupilot.com/wiki/building-ardupilot-with-arduino-windows/"
"You need to press safety switch for signals for esc.
I have dji opto esc-s and start beeping still I press safety button."
I have dji opto esc-s and start beeping still I press safety button."
"OSD Toggle Channel ch 6 for example
Rotation Switching off
CT Tool for MinimOSD Extra 2.4.0.1 Pre Release r788.zip, 479 KB"
Rotation Switching off
CT Tool for MinimOSD Extra 2.4.0.1 Pre Release r788.zip, 479 KB"
"Minimosd software version?"
