Gender
Male
About
Location
Barcelona
About Me:
I work as a computer programmer. I enjoy playing with electronic stuff.
Please tell us a bit about your UAV interest
I would like to find an UAV related job.
Hometown:
Flix
Activity Feed
"Wow, I'm doing something similar but with IR leds and this is much more powerful! You don't need to keep the camera pointing at the leds."
"Nice! I'm doing something similar but instead of using a pattern image I'm using infrared leds as waypoints but for now I haven't integrated it into the ArduCopter code."
"I also had some problems with the infrared trigger. My problem was the sun light, I used more tape layers to cover the led emitter and the problem disappeared. I used an Arduino to trigger the shot every few seconds."
"Here is my setup:"
"I've recently made one of Tarragona (Catalonia, still in Spain): http://pan0.net/upano.php?id=3788 It's not so glamorous, but it's a 360º aerial panorama ;)"
"My board is ok, I've tested it with this test: http://stuff.storediydrones.com/ArduIMU328_V3_Arduino_Test_Code.zip
By the way my board is v3."
By the way my board is v3."
"I've the same problem, only roll works, but partially because if I pitch the imu board roll servo also responds to it."
"I agree Harry, KISS philosophy ;)"
"Parece como si una bobina del motor estuviese cortada, si puedes prueba a cambiar el ESC por otro, así descartas cualquier fallo del ESC."
"Este vídeo me sirvió de ayuda. Colgué mi Y6 de dos hilos y configuré parámetro por parámetro tal y como lo describen en el vídeo.
OpenPilot TV Episode 2: PID Tuning from OpenPilot on Vimeo."
OpenPilot TV Episode 2: PID Tuning from OpenPilot on Vimeo."
"Es de agradecer poder hablar en mi segundo idioma, se hace pesado hablar siempre en inglés."
"I don't use any connector, I've soldered the wires from the distribution board to ESC and from ESC to motor."
"Bullet connectors... people in the forum are always saying that it's a source of problems."
"Look here: http://www.flytron.com/19-rc-shutters. By the way I use an Arduino Pro Mini with an IR emitter as a trigger for my Sony NEX-5."
"Compass noise solution (dji style):
Here the results:
With compass attached to APM1:
With compass attached to dji mount:
Noise is gone! (But I still have yaw problems, it doesn't hold its position, I suppose I need more PID adjusting).
I've used…"
Here the results:
With compass attached to APM1:
With compass attached to dji mount:
Noise is gone! (But I still have yaw problems, it doesn't hold its position, I suppose I need more PID adjusting).
I've used…"
"A comparison between this system and one simple without dampening would be great. Sometimes adding a dampening system can get it worse. I give up with the dampening on the motors, I'm trying this dampening direct to the camera gimbal:
The idea…"
The idea…"
