Hi!I am working on the control algorithm of quadrotor after its one rotor failure.I am trying to stabilize the quadrotor structure loaded with a trirotor firmware (available in MISSION PLANNER) on APM2.5.Anyone please helo me wether is it possible to
As we are supporting community mapping in Borneo and Papua [Indonesia], we have been able to, so far, use our multirotor [tricopter and quadcopter]. However, the customary forest that we are about to map are way too large to be mapped by mul
After many hours setting up my finwing penguin i had it read to go for the maiden flight.Below are the first attempts by a friend of mine - A very experienced pilot.
What is wrong with this? The plane is using manual mode - it should be working
This is a feature I have been considering implementing. However, I am not overly familiar with planning missions. Perhaps there is an obvious workaround that I do not see?
How does everyone handle wind during auto landings? You could plan the landing
I think what I am experiencing is called a stall spin. This happened in auto mode while the plane was heading to a WP when the plan starts spinning in a very tight loop and drops altitude. I had the sun in my eyes and could not spot the plane and tha
When I select auto mode my throttle is completely or very completely cut and my plane starts to drop altitude until I am uncomfortable and have to hit manual mode to recover. I have attached my logs and hopefully someone can take a look. I d
I finished my new airframe which is much better suited to the extra hardware required for a UAV than my previous attempt. I was successful launching, flying and landing in manual mode. My goal was to autotune, however I must still have something
Is this possible to activate a servo from a clap on the ground, with a directional microphone orientated to the ground and sensor connected to the apm or to the receiver ?
I have found the df13 to be the only source of all my delays with the apm, which cost me maybe 20 times the cost of the apm and months of trials and failures.
Is there anywhere anyone to sell an apm with plugs like servo plugs ?
As i prepare for my very first Plane flight i wonder what throttle and elevator value to put on the transmitter as i throw the plane into the wind. Should i give 100% throttle and 100% elevator in manual mode or what is the standard procedure here [F
I have not flown my finwing penguin yet. In manual mode the elevator moves alot (100% i would say). In FBWA mode the elevator moves about only 30% up and 30 % down compared to Manual mode. Is this expected? The same looks to be true for the ailerons
I have located my 600 mw Immersionic FPV transmitter in my Finwing penguin fuselage. Shoud it be located outside the plane to cool it or has anyone any experience ?
Does anyone know what might cause the plane (Skywalker 2014 with pixhawk, 3dr gps/compass) to always fly to the right of the waypoints? This resultsin my planned flight lines being alternately too close, then too far, apart. This happens every fli
I found this topic in "troubleshooting", but the suggestions didn't help.
The plane has been working fine in FBWA, auto, etc., but would only operate in manual mode today. I don't see any errors in HUD or from telemetry logs.