All Discussions (70)

Sort by

APM 450 Helicopter tuning

Thanks in advance
Newbie to APM helicopter and need some advice. I have used APM 2.6 and 2.8 board for a few years now on quads and tricopters. I have watched videos of APM helicopters flying waypoint missions with no input from the transmitter a they

Read more…
1 Reply

T-Rex 800 Pro DFC Params

anybody out there how can help me with some good PID Values for 3.3.3 to start?

My first two attempts were unsuccessful and that could be very expensive. If it's a secret, I would be willing to pay for it (Paypal) :-)

Mechanic: T-Rex 800 Pro DFC with s

Read more…
15 Replies

Dominator 450L APM 2.6 Build

I had a Dominator 450L sitting around and I decided to install my old APM 2.6 so that I can continue to 3691249858?profile=originallearn traditional helicopters with out jeopardizing my 700 Trex with a PixHawk. So I have had success setting up traditional helicopters.  This is

Read more…
3 Replies

Trex 600N w/ Futaba 8JA

Does anyone know where I can find a wiring diagram or more info on adding a PixHawk to a traditional gas helicopter (it's really a glow engine but you know what I mean)?

I'm using a Futaba 8JA transmitter for my helicopter and a Taranis for my quad. R

Read more…
0 Replies

Confused on ACRO

There seems to be some conflicting info in the documentation.

The link below says ACRO is frame reference, but the next link says earth reference.  The first link makes no distinction for traditional helicopters.  Has the firmware been updated and the

Read more…
3 Replies

Trex 500 Parameters

I was hoping someone in the traditional heli forum could share their current parameters file (flying 3.2.7) if they have a Trex 500 in flybarless configuration and are happy with the transition and hover in stablize mode.

As this is my first trex 500

Read more…
2 Replies

Problem with RC Channel Mapping

Hi Everyone,

I have not posted here before and have been building a Trex 500 Flybarless (new 500L rotor head) as a testbed for the tradtional branch of APM.  After loading the correct firmware (V3.2.1) in the APM2 Planner, I went to calibrate the radi

Read more…
4 Replies