Gender
Male
About
Location
lahore
About Me:
Electronics and UAV intigrator.
Please tell us a bit about your UAV interest
www.techno-crafts.com
Hometown:
Lahore
Activity Feed
Hi I am facing problem in position hold mode for X7 flight controller, stabilized and altitude hold mode works fine as soon as I switch to position hold the quad is unstable any suggestions I have autotune roll axis and same parameter for pitch…
I wonder if anyone tested dji ocusync air and racing goggles with pixhawk mavlink data and hd video.It has input for futaba tx and sbus output also mavlink support with hd video and 7km range.
"It seems you are getting power +ve from main wire of battery and ground from balance connector other wise both wires should melt check your main connection to speed controller it is not connecting main ground wire it is taking ground from your…"
"You need some mechanism to stop the shuttle otherwise it will hit at the end better to take pulley in center and use your bunjee to take the shock."
"Hi Tridgell / Gary
If motor stops and plane is in auto mode loitering over head will it decent in glide mode or try to give elevator to maintain altitude . As in my last flight it nose dived after motor stops on low voltage."
If motor stops and plane is in auto mode loitering over head will it decent in glide mode or try to give elevator to maintain altitude . As in my last flight it nose dived after motor stops on low voltage."
"I have done a 2M wing with composite and non composite versions will start producing them shortly."
"Jeff what is your RTL altitude?"
"I am also working on interfacing with Skylark ata . there are two options first to get signal through audio channel of video TX and second to get output from Mission Planner in second case have to make some sort of interface. i dont know what…"
"about 20min on 5400mah 4s 14.8v pack with 3 x packs aiming for 60min."
"Today Auto takeoff worked perfect will try auto landing in next flight any suggestions on approach of autolanding height and distances."
"Wing span is 2 meters airfoil is bit custom of mh series"
"Thanks to every body specially Tridge / Gary
Just Tested with new calibration worked perfect tuned with auto tune. tested FBW_A and auto mode also worked perfect. The P gains were too low as default . will test auto takeoff and land and will…"
Just Tested with new calibration worked perfect tuned with auto tune. tested FBW_A and auto mode also worked perfect. The P gains were too low as default . will test auto takeoff and land and will…"
"Yes We will produce them shortly any suggestion are welcome. They are made from EPS covered XPS sheet then covered with Plastic film ribs and center structure are cnc cut plywood with carbon fiber spar.It can be fitted with front or rear motor What…"
"Hi Tridge
attach pl find the log of successful flight.
Ahmed2014-10-02 13-36-48.tlog"
attach pl find the log of successful flight.
Ahmed2014-10-02 13-36-48.tlog"
